Search results for query: *

I recently bought an s4 avant,haven't used it yet as just waiting for the insurance to run out on my old s3,trouble is the key for it has gone missing either lost or eaten by one of my dogs,if I were to buy a lock set from a car being broken what would I need to get,will I need the ecu aswell...

I bought a brand new battery for my S3 on Christmas Eve as the old one had died,I had to do some work on the car last Saturday so it had been stuck on the drive up until last night,I had left it unlocked all week and on Thursday I started it up and it started fine and I left it running for...

Finally got my s3 running Saturday,took it for a run round the block to clean the brakes up as it had been stood a while,while I was out it popped a boost pipe off,I managed to limp it home an it kept cutting out under strain cause of the pipe being off,I got home and turned the car off and left...

Is there 2 different sorts as I might change my rods soon and looking on eBay for head gasket sets,there's a seller on there with a complete gasket set and bolts but says in the description that there's 2 different sorts of head bolts

Any way of telling a rod might be bent without taking anything apart,recently had a ticking noise start on the engine,have used a stethoscope and can find the noise when it was on the o/s engine mount but nowhere else,I thought it may have been a tensioner or water pump so did the cambelt and...

After changing my ecu I've always had a hesitation which I thought was coilpacks,I've changed them for red coil packs and the hesitation is still there,scanned the car with the computer we use at work and it came up with a few faults but there is 1 fault that won't go would this point towards...

I've put a different ecu on my apy s3,I've modified the wiring slightly to get the ecu to work,it ticks over fine and revs up fine but when you drive the car it gets to about 3500 rpm under load and misfires but if you drive it gently it will rev through fine,does this sound like a coil pack...

Has anybody got any engine loom wiring diagrams for an apy s3 with and without esp please,I'm just trying to figure out if there's a way to wire in an engine control relay so I can run an esp apy ecu on my car

Does anybody have any diagrams on how to wire in the j271 engine control relay into a non esp apy S3 please

I bought an ecu for my car a couple of weeks ago,said it had stage 2 revo remap and immobiliser defeated,I've put the ecu on my car and it starts fine but won't rev up and ticks over lumpy,I've put the computer at work onto the car and it shows up fault code 17925,says main relay j271...

What would a rough estimate be for power on my S3 with the following welly cooler 3 inch down pipe straight through to milltek back box badger TIP k&n cone filter revo stage 2 remap aftermarket dump valve also it's an AGU engine is there anything else people might recommend,I will get a...

The car will run perfect on tickover but starts to smell very rich,also I keep getting a boost cut sometimes aswell,I've plugged the computer into the car and the fault code 17963 comes up saying maximum boost pressure exceeded but that's it,there's no other codes come up to explain the running...

Does the TT Quattro suspension fit on to the s3 atall or are there differences that won't allow it

Got in my car (apy s3) this afternoon when I finished work and started it up it started ok as usual then the epc light came on,it was hunting through the revs then dropped down to tickover, I turned it off again the restarted it and it did the same but then when it was ticking over it started...

I've got half leather/half alcantara trim in my s3 and the drivers seat is starting to get a bit grubby as I'm always getting in the car with my work overalls on,I'm going to get some good seat covers soon but want to get the seats cleaned 1st,what's the best way to clean them please

Just went to use my air con in my s3 and it doesn't seem to be working,if you push the air con button the symbol comes up on the display but then goes straight off again,the last time I used the air con was a couple months ago and it was working,is the problem more likely to be to do with the...

I think the head gasket might be starting to go on my s3,I've got an agu engine in it though so would I need to order any specific parts or will I be ok to just give my reg for the parts,I'm going to do the cambelt aswell so again do I need specific parts or everything ok to go with the reg of...

I've put an agu engine into my apy S3 then had to change the oil pump in that,got that all done last night and all seems well apart from a couple little things,while I was changing the engine I got rid of the sai then also got rid of all the pipe work for the n112 and n249 but left them plugged...

Does anybody have any wiring diagrams for an APY S3,I changed the engine in mine over the weekend and since it's all been back together it feels sluggish,I just need to make sure I've reconnected all the plugs back to the correct sensors,some of them are obvious but I found some of the plugs...

Which way do they wind back in please is it clockwise or anti clockwise