View attachment 151589 Ok so I am getting privet messages wanting how to wire the auto hold kit, so thought i`d post it here.
I haven't done this before as it`s quite easy to get it wrong if your not that intimate with your cars wiring system
Please do this at your own risk
THIS IS FOR AUTO HOLD KIT S-TRONIC
There are two kits available that I know of, I used the Kufatec one
https://www.kufatec.co.uk/shop/en/r...assist-audi-a4-8w-a5-f5-automatic?action_ms=1
1 x AUTO HOLD SWITCH (at the time i did mine they did not offer RHD switch so I bought LHD from Audi)
1 x WIRING LOOM
1 x CODING DONGLE
no instructions!!!!!!
Auto hold switch plug has 6 pins(only 4 wires used)
pin 1 connects to control unit (j519)in passenger foot well connector B pin number 31 of 73 pin plug
pin 2 is ground
pin 3 connects to control unit (j519)in passenger foot well connector A pin number 17 of 73 pin plug
pin 4 connects to control unit (j519)in passinger foot well connector A pin number 32 of 73 pin plug
pins 1 and 3 do the Auto Hold switch on/off - canbus system
pin 4 lights up the switch when lighting is used ( please connect this to the correct pin as it uses a data signal to work ) it can also be connected to pin 5 of the 8pin electric handbrake connector if you want as it comes with no connector and has to be spliced.
Then you plug the coding dongle into ODB port takes about 30 seconds to do, don`t panic as it throws up lots of errors on the dash as it does its stuff
It all works as factory fitted, you will wonder how you drove without it.