I've just done this on our Golf. I presume it's the earth pin that's failed? Does the grey plastic piece allow you to take it off the cluster? I was able to get the parts all separate and including repair wire for (earth in my case) was around £65. I modified the new part to run another earth...
Can't say as I've had the issues you speak of but only at 85k. I've had injector seals replaced at my insistence because they're ultimately not a lifetime part. Mine is a BiTdi but otherwise the same. It's serviced yearly and never at the main dealer since I've had it. Audi main dealer did do...
Google earth maps have been dropped by Audi on the C7 C7.5. It is not data you're short of, it's a software setting that Audi didn't want to update/pay for etc. It works in other platforms, but it was intermittent for a while and now does not work, along with live traffic data. Presumably that's...
It is condensation. The air con is working extremely well making the inside cold but the outside is warm. Is the windscreen clean or is there any coating/polish causing it to mist?
Sent from my SM-S908B using Tapatalk
I'd still suggest checking compressor first. 2017? It will have cycled many times and nothing lasts forever. If your suspension dropped it could even be (unlikely) a faulty valve block. Can you fill the air tank and raise the car that way? The lights are related to the level being incorrect, you...
So purely looking at this logically. The warning lamp came on when the suspension collapsed? Does the compressor run? Have you noticed the car sagging prior to the collapse?
Irrespective of what module is fitted, the loom will have minimal differences. I still strongly suspect that the loom is broken just after it comes into the car. A continuity meter will help pinpoint the fault, but ideally, the bumper needs removing and the loom taking off it. It is a simple job...
The rears plug into the module nr fuse box, and a loom from the front sensors comes to the module, and finally a third loom goes to the car for power and can wires etc. Box is very roughly 100mm square and 30mm thick, and will be pushed and clicked into the rack behind the suspension/fuel filler...
Right rear, near fuse box behind the panel you unlock with a quarter turn. It's clipped in one of the racks. Easier to look behind the panel where it comes into the car, roughly underneath the outer light but inline with the sensor area and follow to the module that way. Sounds complicated but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.