Your fault codes are different from the ones I had. One of the your fault codes refers to a comfort data bus and I believe the earlier models had a comfort control module under the drivers seat, which mine doesn't have. So your wiring could be different. When I was researching the problem, a...
On my car it is the purple/white wire that is the control signal to the rear right door module. My car is a 2013 model, so the colours could possibly be different on yours. There are only 3 wires to the module: power, earth and control. The control wire is thinner than the others.
Start by removing the trim from the side of the foot well (see picture). You should be able to get to the front end of the loom as it runs along the cill under the plastic trim. There is almost certainly a break in the wire as it runs from the gaiter into the car body, behind the trim panel.
Before you pull off the door card I would check the continuity of the purple/white wire in the door gaiter. The wire runs in the loom alongside the driver's seat above the cill.
Problem solved.
It turned out to be a broken wire in the loom gaiter to the driver's door.
Pretty poor for a car that has only done 40k miles.
Hope this helps others on this forum
I fitted the new module today, but as I feared I still have the same fault - no CAN gateway communication to the door module. here is the VCDS output:
01334 - Door Control Module; Rear Right (J389)
004 - No Signal/Communication
Freeze Frame:
Fault Status: 01100100
Fault Priority: 2...
Hi, I haven't solved the problem yet. I have power to the window module, the door switch and the fuse are OK. I have tried swapping all the relays under the dash. VCDS show no communication to the window module. I have ordered a new module (expected delivery is 21st May 2018 and hope that will...
I have connected a VCDS to mine and it says no communication with window controller.
The door switches and fuse are OK. I have ordered a new control module and hope that fixes it.
But, I am now worried that you have changed the module without success. I will post the results once I have...
Hi, I have exactly the same problem with my 2013 Audi A3 Convertible. The driver's side rear window doesn't work and this prevents the soft top operating.
Would you mind telling me where you found the solution?
Thanks
David
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.