Recent content by tonycb6

Does anyone have experiance of Ceramic Polycarbonate lamination compaired to film lamination? i have a quote from 2 companies one quoting the Ceramic Polycarbonate and the other quoting using Llummar film. Is either better than the other? many thanks tony

thanks,i will give them a look. tony

Anyone know somewhere near Cambridge to have tints done? thanks tony

ditto above

ok,i managed to get the box fitted this morning,not as straight forward as emmo's instruction as our car wiring seems to differ.I dont have fuses for the fog lights,my lights are controls by J519 on board supply unit.All turned out simple after i printed of the circuit diagram from elswin...

Emmo hi,i received my box this morning and reading the install instructions,the instruction ask to cut and reconnect the box between the light circuit ie cut the l/h light feed and connect yellow and yellow/black from the box to the cut wires.if so are the l/h and r/h light cables behind the...

thanks for that,with regard to the connctions to the fog lights,did you splice into the cable at the switch or run cables done to the light unit? just ordered the unit from the link above,worked out £18 at current exchange rates.

Emmo,could you tell me where you installed the box and could you tell me where you picked up the connections please. Looks like a nice simple bit of kit. Many thanks Tony

Hi,yes i like those lights too,couple of questions, I see that they are plug and play,does that mean the drl's are now your sidelights? or did you fit the drl switch? Also are the drl's a light strip or led bulbs that can be replaced if they blow?Or does it mean fitting a new headlamp if the...

Hi,my rnse also does the same,where it losses the ability to shut down properly and also stops the display on the dash,the problem started when i fitted a dension 300 ipod kit.The only way I can get this sorted is to unplug the rnse and disconnect the dension and reconnect all back up.My problem...

still need help on this one,anyone able to help?

Hi guys,i also brought the interface from ebay,could someone confirm the connections fro the interface to the rnse? on the big plug on interface,i have 4 seperate wires,brn=ground.red=12v(is this perm 12v or live from the reverse light? then orange/violet=c-bus high and orange /brown c-bus...

Sorry for delay,am I right in saying that the looms will power up the new lights under the doors(to be drilled and fitted) and also convert the red reflectors into a red light?or do the reflectors stay as a red reflector? If so do i need to buy 4 light units or 8? Are the part numbers that are...

Hi,I have read through this thread and was wondering if the retro fit kit would fit my 2006 b7 A4? I saw the post by Robin saying that a couple of wires were longer. Could anyone confirm if this would be possible? Many thanks Tony

Just looked on vagcat its item 22 dryer.So it looks like the o-rings/seals on the dryer have leaked.Hopfully a cheap and easy fix(for audi). Tony