Recent content by HaloPreka

After updating the firmware is it possible to activate Video in motion with Green Enginering Menu or only with OBD Eleven?

I did the map update for a second time, on a second A3 8V FL, and everything went fine following this procedure. According to this: 9. To activate CarPlay, Google Auto and Video in Motion hit the option 'patch_ifs_root_aio' 10. Hit the option 'Flash_patched_image |add FECs | CP/AA coding'...

Did anyone done the actual auto hold coding for the FL cars with or without the button? So it can confirm that it is actually 100% working.

Yeah, better not to do it until warranty expires. Mine car is FL from 2018, and it is not under warranty, so I could do it, but the problem is I can find the way around coding, but I am very bad at wiring and that stuff. Did you find any good tutorial for fitting the button and loom? If yes, it...

...

Hey. No, I was confused also. But I tried on the same module you have and it is only for PFL cars. For FL cars coding ia different but I guess it does not work without the actual button. Auto hold is enabled, but because of the error it does not activate it. Here is the thread with correct...

@FPSUsername So this should be it, summarized in one post. Can you confirm? Address 03: ABS Brakes Adaptations: 03-ABS -> Security-16 -> Code "20103" -> Adaptation-10 -> AUTO HOLD functional status, always active 03-ABS -> Security-16 -> Code "24990" -> Adaptation-10 -> AUTO HOLD...

Yes, of course it should be manually done. I will try to read the thread you mentioned. and see if I can figure it out. But, I am not super familiar with VCDS coding, I have done some basic stuff. It would be perfect if there is one post where everything is summarized.

Hello, sorry for jumping in on a topic. So, for this module bellow (which is in my car), auto-hold can be coded without a button? Address 03: ABS Brakes (J104) Labels: 5Q0-907-379-IPB-V1.clb Part No SW: 5Q0 614 517 CF HW: 5Q0 614 517 AD Component: ESC H25 0513...

Ok, clear. I don't need AA that much, since I will update maps, but it is not bad to have. Many thanks for your answers.

Hey, thanks. Yes, I can write on the rotary button and the car has virtual dashboard, so it is MIH2 than. One more question, car has only one USB port marked "charging only", so I guess it is not possible to activate Androdi Auto or CarPlay?

Can someone confirm is this MIH2 unit which I have on my car?

So... I replaced the seats on my car. It went smoothly as it can be. Just followed instruction on from ELSA on removing/installing seats and everything was done without any problem. Of course, it could be done without instructions, it is not rocked science, but it was useful to do it...

I tried this method which is shown everywhere for this car model: Byte 08 - Bit 1 Byte 19 - Bit 6 Byte 23 - Bit 0 My car is Audi A3 2017 FL sportback with Manual gearbox. It will not even accept changes to Byte 08 and Byte 19, and when I change Byte 23 - Bit 0, immediately error "parking brake...

I don't have new seats yet, but those plugs are looking exactly the same. And yes, both are heated. Any VCDS coding needed?