Hi . Matt.
I got the OTOFIX D1 PRO Car Diagnostic Scanner Really good price on Amazon at the moment.
Every one in the family has different makes of cars so it was worth the expense.
Andy
It turned out it was a bad coil on cyl 4.
I got a new diagnostic tool and it showed the counts of misfiring on that cyl. The misfiring count just kept going up. I swapped the ignition coil from cyl 4 to cyl 1 and the misfire count shifted to cyl 1.
Fitted 4 new Bosch ignition coils and...
Audi A4 2.0T FSI B7 Manual.
Before this happened I had no codes and the car ran perfect. I drove the car yesterday and about 1 mile into my journey I lost most power and the engine is running very very rough. I only drove it at 30MPH before this happened. I have the engine check light flashing...
I now what you mean.
Hopefully it will pass its MOT OK. It's like going down a rabbits hole. I don't know what I will find next and there has been plenty. Still trying to sort some of it out.
I've fitted the 2 new Febi ABS sensors and the fault code has cleared.
I just need to drive the car to finish off the steering sensor calibration.
Thanks
I have found the answers from a web site.
1700 ohms is good
This was posted by Voxmagna, Thank you to him. Hope he doesn't mind me pasting part of his thread here.
The ABS controller carries out two tests on the integrity of the wheel speed sensing system. At key on the controller looks for a...
I thought I would get the multi meter out and this it what I found.
I disconnected the ABS sensor plugs behind the rear seat left side and I got a 1700 M ohms reading. Is this the correct resistance?
I got no reading from the right side. Probably due to the wiring or a failed sensor.
I turned...
Found 2 new sensors on Ama*** at £13 each, a no name brand. Do you think these will be OK or can you suggest some that are cheap that has already been tried and tested to work alright?
Don't want to chuck good money away on a pita job like this. Rather do it once and forget.
Soon as I looked...
I used the OBDeleven scan tool.
Came back with 2 ABS fault codes, left rear 00290 and right rear 00287.
Can you recommend a Tap set that will do the job?
I took some pics and I might have found the problem. These 2 pics are from the rear left. I do not know if the right side looks the same yet.
Is the gap between the ABS sensor and ring too wide?
It looks like someone might have put a new sensor in on top of a lair of old rust without cleaning...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.