Recent content by Sean Devenney

sounds brilliant mate, there isn't much if any difference, both have mk1 RNS-E in them etc and all software for the components are the same bud.

09 reg was the start of the facelift models. I am collecting a 09 reg S3 on Saturday morning, S-Tronic. I personally prefer the facelift models so 09 onwards you should be good. Also RNS-E as you mentioned, and all round a better looking car. Let us know what you find and what you get. Will you...

Only 12 days to go lol...longest month of my life!

Thanks mate. I'm open to changing my mind, I'll have a look at black chrome. I have gloss black alloys on my A3 and they just collect dirty like nobodies business lol. Yeh will be lowering it about 20mm I think. and looking to De-cat it and remove the centre silencer to make it quite a bit louder.

Can't wait for the drive Sandra, what better way to spend new car day than getting to drive in your new car:)

Finally found myself an S3 with the spec I wanted and went ahead and bought it! Spec: S-Tronic, Heated Seats, Facelift, RNS-E, Flat Bottom MFSW, Full Leather. Car also has full Audi service history (I work for Audi so I checked myself:tongueout:). Will be looking to go APR Stage 1 and do...

Thanks bud, just going to go down the custom road, saves me having to get manifolds and things like that replaced aswell:) Cheers

Thanks mate, think custom is the road to go down...saves me spending a fortune on say a milltek for it to need butchered to fit lol.

Hi Guys, Looking for as much advice as possible, I currently have a 2.0 FSI (non-turbo) A3 and I am looking at fitting an exhaust as I want it to be louder than stock. Basically I have 2 options, go custom or buy an exhaust for the 2.0TFSI and fit that...my question is, is it possible to fit a...

lovely looking car mate! congratulations and good luck on the wedding too! Hope to see more of this car as you go along buddy!

This has happened to myself, battery died, key fob didnt work could not unlock the car...What I had to do was jack the car up and remove the scuttle panel under the engine and then connect the jump cables, positive to your starter or alternator if you can find see it from under the car and the...

It's not unfortunately, its a FWD 2.0 FSI, I'm having to go custom due to the cost...I can get a full custom stainless steel from cat back and my cat repaired for 500-600, and any milltek I have seen is easy 700+ so I'm goina go customer for sure, just looking to see if yous have any ideas as to...

hmm thanks very much mate, i'll take a look. Any idea's if I'm going fully custom how I would achieve the crackle buddy? thanks:)

what mate?