Hi guys,
I know this has been posted to death but I cannot find an answer to any post with the same symptoms as me.
I had a front end crash a month and a bit ago and everything is repaired now. I had to re-learn the VIN number to some components and I think my VIN is missing from my instrument...
Just thought I'd update this thread in case anyone has the same problem
Replaced the fuel pump relay, no change
Replaced the crankshaft sensor, everything seems to be good now! Done about 30 starts since I replaced the sensor and none have failed or taken longer than usual.
Thanks guys!
Thanks guys, is the FP relay the 9 pin labelled "167"?
And is the crank sensor the one mentioned below?
http://www.pelicanparts.com/techarticles/Audi_B6_A4/12-ENGINE-Crankshaft_Positioning_Sensor_Replacement/12-ENGINE-Crankshaft_Positioning_Sensor_Replacement.htm
Hi,
I've run into a problem since yesterday intermittently whereby my car will crank and crank but not start. Randomly it will start, and randomly it won't. It's happened about 3/10 starts since yesterday, no new codes are showing (except G28 speed sensor), I was told by a friend it may be...
Thanks for the advice. I saw a specialist and he said it sounds like the 3rd gear clutch isn't engaging from 2nd and disengaging from 3rd, when going to 4th so that's gonna be a big job. Going to get the fluid and filter changed on Friday so hopefully it helps
I'm going to see a gearbox specialist on Wednesday who can hopefully help. I saw a guy around me and he said it's gone and it's a minimum of 1700 to recondition
Bump, I tried to change the auto trans to only paddle shift when in manual. The same thing happens, every time I press the + or - it shifts twice, then other times I press it and it doesn't work. I checked the measuring blocks again and every time I press the + or - it works fine (tested 50...
@NHN @bearthebruce any ideas? Yesterday I checked all of the 'Vehicle Speed' measuring blocks (selected them using advanced measuring blocks) in Engine, Auto Trans and the ones in ABS brakes and all were fine. I'm not sure which sensor sends the vehicle speed signal to the Park Assist module...
They said the fluid alone came up to around £280 which is way too much, but as you've said Mike, I've heard using the wrong ATF can cause more problems than before changing the fluid
I had some spare time yesterday so I used the VCDS to try and see if any coding or adaptions could be made to the steering wheel or transmission. I logged into the auto trans and changed the coding for the Tiptronic mode from Tiptronic in drive + tip mode, to just tip mode (I believe it's the...
I spoke to Audi yesterday and they are asking for £350 for 6 litres of fluid, gasket and the filter.
If I'm getting jerky gear changes and a small whine/groan when changing gears and accelerating, would a fluid flush fix this or does it point to a bigger issue?
Hi guys,
I got my S4 just over a year ago and can't see any record of the ATF being changed. It's at 87k miles now and the transmission is getting jerky when cold and is now making a slight whine when changing gears. I'm going to do a flush and change the filter but am not sure exactly what I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.