Recent content by Aco B

Yeah, I had rear sensors, and here are cost: 1. PDC+PLA Module -------------------------------------40E - scrapyard 2. front bumper wiring + 4 PDC sensor-------- ------40E - used, Ebay 3. PLA sensors x 2----------------------------------------20E - new, Ebay 4. PLA+PDC cabine...

One more in the club! Finished the retrofit today (after small Korona pause). Thank You all for help, especially George's wiring drawing, that helped me to create my own wiring from scrapyard wires (not Kufatec, saved 80€). Total cost 150€. Works perfect (tested both left and right side...

Have you done anyting after "figured out a solution"?

Solved this morning. When I opened bluetooth connector I slided this blue part (with 2 rows) on wrong side of black holder (with 3 rows). Luckily, RNS-E and Bluetooth Unit are OK, only 15A mini fuse died, :). Now everything is normal.

Small problem... Today I placed wiring from Ecu to engine (noting connected yet, only preparation). I had to remove RNS-E from quadlock, and bluetooth module from connector. After much gain with this, I put battery back, then connected RNS-E and bluetooth back in place, but no power on RNS-E...

I have small issue with wiring. My front bumper wiring is Audi genuine, 8p0 971 085B, from scrapyard, not Kufatec. I added 2 extra connectors for PLA sensors. But according to original wiring diagram and pin-outs, this genuine wiring must go from right to left side of bumper (8-pin connector...

Is this problem, or good thing?

Thank everyone for help. But I manage to find appropriate one, model "K", on scrapyard in town near me, €40, with postage. Already bought front bumper wiring and 4 sensors. Sensors on back bumper are factory fitted. Now to collect other parts, and then to work. Wish me luck!

Does anyone know, is it possible to use other model of PLA module, for example, from Audi A4 or from similar cars, like VW Golf MK6. Audi A3 8P with PLA (or even with 8K module) are very rare, and hard to find