Recent content by AdamskiQuattro

  1. A

    Sold A4 b7 xenon headlights

    Thanks! Think it can be closed and marked as sold:) Adam
  2. A

    Sold A4 b7 xenon headlights

    I bought them on Ebay bud, they were shipped over from Germany.
  3. A

    Sold A4 b7 xenon headlights

    Hi all, I have a set of a4 b7 xenon headlights, complete with bulbs and power packs. All fixing points are intact. I had these on my b7, but now sold the car and have these collecting dust. I also have a set of adapters, if your b7 came with standard lights, although believe I damaged...
  4. A

    2.0T fsi oil pressure warning light

    Believe a damaged PCV valve can also cause the pressure light to come on. Are you able to take of the oil filler cap once engine is running?
  5. A

    Bi Xenon High beam issue

    Just had a quick check of the wires but can't see anything obvious. I'll take the lights out again over the next weekend and hopefully will be able to find the fault!
  6. A

    Bi Xenon High beam issue

    I had a slight development on this, so hopefully going in the right direction. Plugged in my VCDS today again and it came back with a fault with the xenon shutters saying "02450 Bi Xenon shutter solenoid (F320) 29-00 Short to ground". I assume this is causing me the issue, just need to find...
  7. A

    Bi Xenon High beam issue

    shutters seem to open fine, and I'm quite sure the wiring is ok too. I might try to measure voltage going to the shutter when I turn the high beam on. If the voltage is constant, it will mean its the shutter motor - which would be odd as they both switch off at the same time. Still need to...
  8. A

    Bi Xenon High beam issue

    Ran it and shows no faults, went into measuring blocks and when you activate high beams it does switch to 'ON' and remains showing 'ON' even after they flick back to low beams.
  9. A

    Bi Xenon High beam issue

    Believe it's 10031
  10. A

    Bi Xenon High beam issue

    exactly, all lights work. Shutters work (for about a second) if I flick the switch to high beams they'll come on and switch off after a second even though the stalk is still in high beam position.
  11. A

    Bi Xenon High beam issue

    I have, which seems to work good with the shutters. After that re-coded the ECU for xenon lights with no DRLs.
  12. A

    Bi Xenon High beam issue

    thanks Jasesapphy! I had a look inside the headlights and found a broken clip inside which I fixed but made no difference to my problem unfortunately. Where is the headlight module located mate? is there any way of telling which one I have?
  13. A

    Bi Xenon High beam issue

    Thanks Desertstorm, I'll have a read! Still why would they switch on for a moment before they go off...