Recent content by Davill9

Hi Does anyone know how the vwag camshaft sensor’s work ? do they cut fuel to hpfp but not the lpfp when they fail. At Subaru main dealer, we would unplug to cut fuel to prime new oil pump etc does the tfsi cut fuel if cps is unplugged ? Does it do anything else also to stop running of car -...

Hi Does anyone know how the vwag camshaft sensor’s work ? do they cut fuel to hpfp but not the lpfp when they fail. At Subaru main dealer, we would unplug to cut fuel to prime new oil pump etc does the tfsi cut fuel if cps is unplugged ? Does it do anything else also to stop running of car -...

Do you know if the canmshaft sensor cuts the fuel to hpfp or could a fuelling issue etc have triggered camshaft sensor by excessive cranking after car cut out. I’m getting 5.5v at the cps connector can’t really test sensor itself without replacing something is stopping fuel from building up...

Hi mate, do you mean the one on fuel rail under inlet or the return one inside of the fuel filter ? Fuel filter is a few months old if that… fuel pressure regulator has never been changed by me as it is having rs4 one when unicorn does the next mapping for me- only thing pretty much not changed...

Got all these first scan but battery was already starting to go flat by then But on the power connected, it’s had low voltage faults cleared and is coming up with static camshaft sensor and low fuel ones still and they won’t clear. When I changed hpfp, releasing the pressure at valve, the rail...

hi guys, I was driving round a slip road earlier and car just misfired and stopped completely. Just got the car home… have 2 faults still showing fuel too low and Camshaft position sensor I have changed hpfp to a new one I have here and no change. I then checked mvb 103 & 106 and my...

Hi mate, Was it camshaft or crankshaft sensor in the end ? camshaft one yeah ?

I think on these they go through a tiny hole in gearbox/block at 90 degrees with an Alan key that needs to be flexible almost and banana’d and is attached to the rear main seal, well just behind it I’ll look at the manual in a bit to make sure as it’s been quite a while since I have done a 170...

It’s just I got so sick of driving with a half a blue roll on my door rest all the time when it rains We’ll atm when doesn’t it rain … it drips down the door onto the ally trim and is starting to make it corrode plus the switches get soaked if I didn’t and I’m always getting wet when I go round...

Has anyone else had an issue with the moulding when manufactured, of the heko wind deflectors … the issue I have is the passenger side moulding has, (where the logo is at far back b pillar section) Got what looks like an air bubble when moulded. this doesn’t look as bad as it is in pictures...

Easy one today… Fitting Heko’s ! car is filthy I know, it’s been off road for about a month or so again till last night for the transmission &4wd rebuild this time. may clean later, tbh it needs it.

Something I didn’t know. I am intrigued myself now unless you mean like when modifying to the high flow version of hpfp internals upgrade ? That’s a good shout on awesome too… I forget they are in Manchester as to me it’s always mail order parts down south

Or superglue ;) Na I’m just joking but it’s because the pcb is quite soft and is a really thin head on the 8v mount I bought from Ali express… Slightly larger washers worked perfectly for me Sent from my iPhone using Tapatalk

Want to say a big thank you for sharing one of the best things I ever did for my s3 Genuinely! It has saved me sooo much time trying to make something up. It’s absolutely perfect for what I wanted You can lift iPhone up and have a dash camera I can see satnav without it on my lap Play...

Want to say a big thank you for sharing one of the best things I ever did for my s3 Genuinely! It has saved me sooo much time trying to make something up. It’s absolutely perfect for what I wanted And the Audi rings was a lovely last touch. Matches the rest of the dash. You can lift...