Recent content by Divakaran

  1. D

    Skoda Octavia Mk2 2010 CLCA engine not starting - no error codes in VCDS.

    hi All good morning and hope all should be doing great. while i am waiting for some expert advise from you i continued my investigation and following is my observation. this metering device N290 is normally open solenoid valve and if you give the signal, the valve closes. so if i remove the...
  2. D

    Fuel Pressue Issues

    hi Sir - today i tried with VCDS and if i remove the metering device the VCDS is catching up the same and reports the N290 is open circuit. if i connect it back the error is goes away. the car starts only if i remove the meter devices connectivity and hangs off if i connect it back. if i remove...
  3. D

    Skoda Octavia Mk2 2010 CLCA engine not starting - no error codes in VCDS.

    hi - greetings and hope all will have a great weekend. please help me for the situation, the car is starting only if i remove the metering device from the high pressure pump and will that be the metering device fault? is there way to test these valves? please advise.
  4. D

    Fuel Pressue Issues

    hi Boby - greetings, my car is not starting and when i checked the HPP fuel delivery, there is none. So i removed the metering device to check what signals are coming and cranked the car, the car started without metering device in the HPP. if i put this back, the car is not starting. do you...
  5. D

    Skoda Octavia Mk2 2010 CLCA engine not starting - no error codes in VCDS.

    Hi All - i was away for while due to various medical reason, i just back and checked the complete car mechanical part, circuits etc. the car is still not starting and when i checked the compression its perfect, the fuel from the fuel tank and the electrical pump are perfect. but the fuel is not...
  6. D

    Fuel Pressue Issues

    Dear Bobby - thanks for your response. I am from India Chennai West side. i did not tried anything with ECU at any time. the car was parked for a while and battery become flat. i charged it and hooked to the car and started for test run. it run almost for 20 minutes with no issue and strange...
  7. D

    Fuel Pressue Issues

    Dear All - . I am from India, i had flat battery and recharged and ****** up to the car and started for running at idle. it was running fine and all ok. i went away from the car and in some time i heard a rough idle from the car and hearing the radiator kicking off to rotate with huge sound and...
  8. D

    Skoda Octavia Mk2 2010 CLCA engine not starting - no error codes in VCDS.

    Dear All - i have SKODA OCTAVIA MK2 2010 model. I am from India, i had flat battery and recharged and ****** up to the car and started for running at idle. it was running fine and all ok. i went away from the car and in some time i heard a rough idle from the car and hearing the radiator kicking...
  9. D

    Fuel Pressue Issues

    Dear Bobby i reset the value and after this i am getting one error saying fuel too low. this is coming all the time, when i put the key and switch on. earlier it used to come in some time. we need to switch off engine and start so the MIL will go away. thanks
  10. D

    Injection unit measurement

    hi - my SKODA OCTAVIA MK2, with 2.0 lit 103/81 with UDS ECM, is smoking out when we change the gear and accelerate. so i need your expert advise what could be the issue? i have the VCDS and wanted to measure the injection unit performance value and compare with the good one. is there any one...
  11. D

    Fuel Pressue Issues

    thanks Boby. appreciate your help. how do i do this? my ECM is UDS, so advance measuring block and then? can you driect it to me please
  12. D

    Fuel Pressue Issues

    hi Boby - thank you so much for your response. I am too far away from your country. i have the same issue as shared by NyB8 in the beginning of this thread. I removed the valve in the HPP and noticed no metal warps. its clean I also removed the return fuel from the distributor after removing the...
  13. D

    Fuel Pressue Issues

    hi Boby Sing - you were mentioning that CP3 pump and do you have the part number for the same? i have 2.0 TDI CR 101/83 engine. i also have the same issue and please help