Recent content by gary3306

As you have MIB2, you need the camera that has the controller built into it. If you contact @DJAlix on here, he will sort you out with a kit

No idea Nigel, I assumed there would be to reset learned values from the old one. Perhaps disconnecting the battery for 10 minutes may have the same effect. Not entirely sure. I dare say the values would update as I'm driving and are re-learned, but it may run lumpy/give bad mpg until it does.

Does anybody know the adaptation procedure for a new MAP sensor, A6 C7.5? Can't seem to find it anywhere? Many thanks

Best thing to do is give @DJAlix a PM and he’ll help you out. I think it will be exactly the same for an A7. As for price, I’ll PM you what my kit cost but it may differ for other kits. Always best to speak to Alex

Easy to fit. Strip down of rear end but I have rods for fishing wires through trim so wasn’t too bad as didn’t need to fully strip out and still followed OEM wiring. If you PM me I can send you instructions on connections and coding with VCDS

Sorted, with immense thanks to @DJAlix, who identified and supplied the correct kit. Gave me pin out locations and coding instructions. The man is a diamond. Took me around 4 hours from start to finish. All wiring follows the OEM wiring and is TESO taped along its length. Only problem I now have...

Done!

Today’s task. Wish me luck

Yea I’d already planned to do that. i have had work done by Alex in the past and would trust his work 110%, however I really want to do this myself. For the satisfaction factor . I just need to get it right because its not a cheap mistake to make

Not getting very far at present mate. I am fairly sure my car will use the newer system where it’s just the camera and cabling (no need for the control module in the boot), and Andy at Audi Upgrades Ltd has said because my car has the High Navigation system, that this is the kit to use. Other...

So I bought a used reverse camera kit off ebay, the part number of which is 4G0 907 441B (The module anyway). I was then told that this was the wrong kit and I needed the camera that didn’t use the module. This was by a retrofit company. I found a brand new kit on Ebay with the part number 4G0...

Has any kind person out there got the Kufatech instructions for wiring in of the reversing camera on a C7.5, or can give me the pin numbers for CAN H, CAN L and +12ve. I believe the +12ve will come from fuse no. 4 in the brown bank in the boot but not certain. Any help greatly received and...

Ok, the rear view mirror does work. However the door mirrors don’t dim. I wouldn’t have thought they would need coding in Am I wrong?

Gotcha. Ok mate I’ll be on it first thing tomorrow. Cheers

I’ll try that in the morning. The mirror glass has the two small connectors for the heated elements but the dimming wires are on a small plug. Is it still possible to get that plug in the wrong way? Thanks for the reply