For anyone doing this on the following controller
Existing coding was
Byte 8 = 89 - new value 8B
Byte 19 = 91 - new value D1
Byte 23 = 72 - New value 73
Byte 25 = 21 - Value unchanged
These were calculated by making the following bits active (1)
Byte 08 - Bit 1
Byte 19 - Bit...
Planning to retrofit front parking sensors to a 8V
What is the preferred method to route wiring from the bumper to inside the cabin?
Options Ive seen is behind the battery through the firewall grommet, or from drivers side.
Any retrofit guides out there please?
Thanks in advance
Does anyone know what PDC sensor bracket to use on the front 8V bumper? (the bumper pdc holder not the grill pdc holder)
Listed on ETKA as no 13 but not a part thats available seperately
Can adapt a generic one but was hoping to get something made for the job
Currently have rear PDC from factory on a 8V FL
Understand noone can activate the PDC display on the MMI, other than Hazzy Dayz which requires a replacement module.
If a rear view camera is installed, will the rear PDC Display be shown as well as the gridlines of the camera?