Recent content by Hayche

Hi bud thanks for the reply, I'm in Bradford Yorkshire any suggestions where to go? If it was crankshaft I'd assume the sound would remain or get worse when pressing clutch in? Do you not think?

Around 26mpg that driving like a good boy. I'm only stage 1!

Hi everyone, not been having much luck with my 2012 s3 8p recently. When car has been parked over night and it is started cold I notice a knocking/rattle noise which disappears when the clutch is pressed in. Then after around 1 to 2 mins the noise disappears even when clutch is engaged. Is this...

Anyone?

Hi everyone hope everyone is well and good. Just wondering at the moment I run B8 T5 F9 on my stage 1 revo. My wife's drives the car alot and I only use in on weekend but it's a real guzzler of fuel drinks like there no tmro I know they not meant to be economical but will lowering these settings...

Yes I've order a yellow one today. Lucky I have a few cars to use in meanwhile so car will not be used! My main worry is it defo won't cause any damage leaving it till next service.

Hi all! Was checking oil this morning and whilst pulling the doomed orange dipstick out the full bottom plastic all broke and fell down the hole! I only had oil change and pickup pipe done 2 weeks ago. Is it OK to leave it there in sump or shall I have sump removed and plastic removed thanks!

This is how it looks. Forgot to mention i put on in the storage box in front too.

They not original lights I used some led strips from ebay. I'll post some pics tomorrow. Look quite nice to be onest! Also I hooked them up so they only come on with ignition. Not with doors or anything I wanted them always on when car is started.

Thanks for reply, but the bolt above it works fine and also this bolt worked for a good 2 hours before the ground and live touched.

Today I was retro fitting leds footwell lights in my audi s3, I connected up everything and was all was running fine, out of stupidty I left 2 wires naked and they touched and the lights went out I checked the fuse, the fuse was fine I checked all wires and led's again all fine so I changed the...