Hey there. Let's break the silence! :D I bought it from same seller, he recommended the rame pins you showed in here. Have you putted the wires in there? How did you fix it in place? They are not very tight if I put them there. :-/
Thank you. Due to plastic indents on button housing, I can't cut a rectangle and put it to door card directly. Did you make a sketch before cutting? Also have you applied any glue? I wish you had a photo while cutting it :)
Thanks a lot.
Thanks a lot for the photos Philip! I also achieved to make it work but however didn't assemble button and housing to door trim yet. Was it an easy job? How did you cut the door card? It looks like I need to glue it from back due that there is no plastic which will hold the housing in its place :/
thanks philip. Actually if you have the wiring with you know, i appreciate some close angle photos of pins and sockets with wire colors. It looks like you are getting 3 pins crossing to some switch (possibly window switch) and the only pin to be in 23th pin in door module. I will try to mimic...
Thank you! But I don't understand. Switch has a 4 pin connector. What are the corresponding pins on door module? Btw, is it working now? Have you changed anything on coding?
Hey there. I ordered the parts at dealer, but havent found the wiring and coding info yet. Hope the parts wont be a waste :) Have you found anything for wiring and coding?
Hi gents. I've found below part for FL 8V. Can anyone tell me the pinouts for connection? I believe 4 pins to be connected Door Module.
Also, i need to make a cut out on door trim for switch. Part Number for switch is 8V0959831B.
Also, is there any long coding change to be done on module itself?
Hi. Very interesting topic :) Have you done the retrofit? I am also interested in doing the same stuff. I appreciate if you can send me the coding info as well. Thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.