James36's latest activity

  • James36
    James36 replied to the thread Raising rear AP Coilovers.
    Made sense, thank you... Got it straight back on stands, even with the arm jacked up I couldn't release the bolt either side, proper...
  • James36
    James36 reacted to NHN's post in the thread Raising rear AP Coilovers with Like Like.
    No, its the other end of the arm attached to the brake side so to speak, use a jack under the arm to take tension of the bolt to undo &...
  • James36
    James36 replied to the thread Raising rear AP Coilovers.
    Thank you! Is it the bolt I've circled in the attachment? (Sorry zero mechanical knowledge I just love having a go)
    • 20210606_100829_compress3.jpg
  • James36
    James36 reacted to NHN's post in the thread Raising rear AP Coilovers with Like Like.
    Drop the trailing arm, its 1 bolt, remove spring, then adjust, refit.
  • James36
    This morning thought I'd raise the rear end of my car, but the whole thing spins when I turn the adjuster with the spanner? Any ideas...
    • 20210606_100829_compress3.jpg
    • 20210606_100821_compress53.jpg
  • James36
    James36 replied to the thread Scraping Rear Arch Liner.
    Ok so the offending screw sheared itself out now I don't have any rubbing... unless the kids are in the back but I am going to raise it...
  • James36
    James36 replied to the thread Scraping Rear Arch Liner.
    Cheers buddy... Think I'm going to go for removing the screw and trimming back some of the felt liner.
  • James36
    James36 reacted to tcardio's post in the thread Scraping Rear Arch Liner with Like Like.
    et 42 sits out more and y0u have stretch and poke but it looks good. look through previous threads as this has been commented on many...
  • James36
    Hi guys after some advice... So I got new alloys as I smashed a pot hole and buckled my rotas... 19 inch, ET42 from ET45 rotas I had...
    • 20210414_130109_compress37.jpg
  • James36
    James36 replied to the thread Engine code location.
    Annoyingly it's just a plain black case, no sticker on the outside or inside
  • James36
    James36 replied to the thread Engine code location.
    Log book says BMN 03G 103 308C, I got this number off the cylinder head but typical both BKD and BMN share this part. Any other...
  • James36
    James36 replied to the thread Engine code location.
    Hi Chris, Surely it's a BMN then as per factory, as that cover doesn't cross over with any other engine. Hmmm, it was a reputable...
  • James36
    James36 reacted to Chris-P's post in the thread Engine code location with Like Like.
    Just using the cylinder head cover part code it refers to a BMN engine code. 03G 103 469 R = BKD,AZV 03G 103 469 AA = BMN,BUY...
  • James36
    Hi guys, Need some help with what engine I've got... My car had an engine swap before my ownership, I believe its not the same code...
    • 20201230_082938_compress82.jpg
    • 20210108_102024_compress51.jpg
    • 20201230_172008_compress38.jpg
    • 20201230_171902_compress78.jpg
    • 20210108_102927_compress76.jpg
    • 20210108_102128_compress44.jpg
Top