Recent content by monty77

Nice one, thanks chaps. Adam

Possible? Seen a lovely S3 near me, great condition and fantastic price but it's got tints, which to be honest aren't really my cup of tea. So can you remove them easily/cheaply? Cheers, Adam

[ QUOTE ] Thanks for the info chaps, I think I'll be going with greenlight but will give the others a call first. Has anyone asked for trackday cover from greenlight and prices etc? I'm guessing the email quotes from greenlight don't do it as written proof? [/ QUOTE ] Trackday from...

Would of thought it's VERY similar to fitting the porker brakes ... the ecstuning website has some guides to help out. Adam

Nice looking car that ... and not too daft on the price, for a dealer. Adam

[ QUOTE ] Good news and bad news! It sold on pistonheads in just a few hours! Thank you ever so much for pointing me to the web site Adam! I sold it for 9900 - which is a bargain for the buyer I think. Wish I could have held out for more - but it has been up for sale for over a month and I...

[ QUOTE ] so it being a facelift would make no difference ? Matt [/ QUOTE ] Nope ... mine was a facelift, AMK engine code = 210BHP .. they both chip to the same power anyway The engine code is also stamped on the engine block, on the left IIRC. Adam

Tried Pistonheads mate? Mine sold on there... Get some pics of the seats too .. people always worry about seat wear. HTH Adam

Spacers make the car look great IMO !! I ran 10mm fronts and 16mm rears on my S3 and it just made the whole car look 'fatter' Biggest pain was cutting down all the bolts to fit as sourcing decent quality bolts in the right length seemed impossible at the time. ...got mine from Forge - not...

Jesus! 2nd crash in that car isn't it? V unlucky.... Makes me mad to see the consquences of other's poor driving, could of been serious injury (or worse) just because some doesn't look where they're going. Nearly got rear ended this morning in the VX because some prat behind me was too busy...

In the 9 months I had my S3 I had: - MAF - Coolant sensor - Clutch slave cylinder Adam

[ QUOTE ] No I think you have to replace the whole centre console fascia, or swap it out with someone who's looking to do the reverse. The OTS fascia adapters are purely to fill in the side bits of the single DIN unit (which has an oversized fascia) when going aftermarket. [/ QUOTE ] ^^^^...

[ QUOTE ] Sold mine but i let it go for peanuts. Wonder if i'd be able to keep up with the vx? [/ QUOTE ] S3 weighs what? 1400Kg? 257BHP/tonne My VX is 247BHP and 930Kg so 265BHP/tonne ...close call! Reckon the S3 would have me top end, VX seems to slow up a bit after 130 especially with...

Mine is sold now too ... someone finally took the time to actually come see it and realise what a good example it is. No haggline, put a deposit on it that evening - obviously had it up too cheap despite what I was being told on here I'm sure I'll be back though, if Audi ever get the new S3...

[ QUOTE ] any good paint and panel supplier should sell TFR (traffic film remover) spray it on, leave for a couple of mins then hose off then continue to clean it as normal. works great on bugs and wheel dust too! just dont ****** off for dinner and leave it on thinking the longer its on the...