Having strayed from Audi once or twice I always find myself going back there!
Picking up a new A4 S-Line a week Monday, counting down the days!
5 Spoke Dynamic Alloys
Pictures to follow :racer:
Only ever been charged once when I took a Jeep Cherokee in for recall work, £20. Otherwise it's always been complimentary but the jeep was 15 years old when I took it in so they knew I'd never spent a penny with Jeep whereas other dealers the cars have come from them.
IMO if you bought the car...
If the window works when you press the passenger switch but not he drivers side then I'd guess it's a switch.
Two posibles here;
window goes down but only with passenger swith not drivers side switch - this is likely a switch fault, pop it out and buy a new one pop it in, £20 if that and it's...
My theory is as follows
Put single din concert in glovebox
Run aux cable to tablet
insert double din cage if not already
Put tablet in cage and use a double din facia plate to hold tablet in, no need for a custom bracket
Job done, you just play everything from tablet to original concert, so you...
Yeah, I'd probably take it to a garage or find a local handyman (there's one in essex that advertise' on ebay). They'll tell you the problem for small fee then you can decide if it's a DIY or garage job
Sell the RNS, don't put either in.
Get a tablet, for £200 you could fit a nexus tablet into your car that has a million more miles functionality compared to any RNS.
I was going to do this but then my Audi went bang, thinking about it I might buy an Audi A4 just to play about with, something...
Audi audio is notoriously annoying, rear speakers and front speakers might be wired differently, and BOSE systems are even worse. You'll end up attacking lots of different wires. I'd contact halfords or a local audio specialist and ask for an all in price including fitting, might be a bit more...
possible tilt sensors
Best thing to do is do a full cycle of your roof manually, ie open it and close it again, or close it, open it and close it again and that will reset all sensors, should work then.
If that doesn't work it could be mechanical failure, in which case diagnostics will be needed