Yes bowman has said his engine is a 1.8t b6 a4. Ive just rechecked my autodata and elsa and you do need to set up the tensioner on these, I don't know what you guys make it sound like im wrong as ive always done it this way, I know what you guys are on about regards the tensioner, the only time...
The tensioner on these doesn't work like that, its not like some japanese engines where you just pull the pin out and it will adjust accordingly , You need to set the tensioner up and measure the gap between the tensioner and the damper body, Ive done loads of these belts and this is how ive...
If the belt was slack, you could get running problems if it was moving the timing out of where it should be, the timing may jump, rattling noises from the cambelt area , poor idle etc....., Its possible the tensioner/ damper was worn out / leaking maybe or i more suspect set up incorrectly. It...
Ive changed a few alternators on these engines with battery light coming on sometimes. Have you tried checking alternator voltage with loads on and some throttle to check its stable? A scan would be useful if you could some how get it done.
Ive known people take their car back to the dealer complaining about this rusting problem and the dealer replaced the discs under warranty. This was at a vw dealership where i worked. 3 months is not good at all , i wouldn't be happy, no matter how much you drive it the rust won't go away on there.
Have a look at this link , I did a search with that fault code, maybe you could do some of the checks they have done : Audi A4 AVF 1.9TDI PD Rough Idle and 17675 - VW TDI forum and Audi TDI forum - myturbodiesel.com
Sounds like a fueling fault you have , would explain the bad starting and rough...
This annoying thud you get at the end of the wiper sweep, do you mean when the wipers are coming to a stop at the bottom of the screen? and are they just noisy in general when sweeping up and down? Ive always found genuine blades to be the best, Im just wondering if your linkage to the wiper...
Ive seen these codes on a 1.8t and it was the breather valve in the breather pipe system had failed. There was a lot of vacuum in the oil system esp when the dipstick tube was pulled out a bit. Please confirm the engine to us though;)
Watch out for the b7 2.0l tdi 140 oil pump/ balancer shaft issues if you do decide to get one, have a look at the b7 section, you should see it at the top.
No one is going to tell you if an injector will solve the problem, If only it was that simple! :ermm: your fault code is an area to start and requires some investigating : This might help 17675/P1267/004711 - Ross-Tech Wiki . Do you know exactly what work was done on the top end?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.