Recent content by sanmark

Well that's actually not a bad idea.:thumbs up: I will look into it, hope to find some BO retrofit coding.

Window switch illumination is insufficient, you get the connector that goes in for window switch but it's not enough power for the leds to work. I will check the door lever illumination wire but doubt it's 12v..I found them on aliexpress, but they are also for 4 doors..

Do you remember where did you take the power from?

Hello all, I have purchased these door interior trims with led lights. And the issue is they don't work on passenger doors. Only on drivers door. I assume it's because of voltage. They come with a splitter connector so you disconnect the OEM one, insert the new then you put the OEM one in it...

Hello everyone, I managed to get a OEM wireless charger for my A3 (2017) and I was wondering does anyone knows the procedure for coding and activating.?

I have managed to slightly move the chrome piece:yahoo:. And for now it's looking good and no more issues with the door being hard to open. Being successful I took a look on the driver's side, and the piano gloss trim looks out of place :wtf:..and the chrome trim isn't aligned with the gloss...

I get it. Thank you for your help Liam. I will try your method with force sliding, because the door is very hard to open because of this trim sticking out.

Does your metal trim hits each other? Because it looks good, there is a nice gap between them.

Mine is also saloon, and yes that pricing is turning me off from dealership..

Thank you Liam, I will try this method..

Do you maybe know if this screw controls the door height it has little rubber cap on it. There are two of these one is up other is down.

Hi everyone, I am hoping you can help with my irritating problem. Passenger door window trim is scratching on another trim from the back door window. And it's hard to open the door from the inside. I suppose the heat is stretching the metal piece..any suggestions other than going to the dealer...

Did you register your new battery to car via software?

Hello everyone, I would like to remap my 2017. A3 saloon. Does anyone here have some experience with revo stg1 on this engine. ? And if can you please share it with me?? Thanks :hi:

Pressure washer with soap, then clay bar with enough lubrication.. very light pressure and I have to emphasise lubrication if not you will leave strike's.