Recent content by schwartza3

  1. schwartza3

    vcds blocks for AGU

    Hi mate, you can't log boost on AGU. You can log timing in block 001 I would also log block 002 (maf g/s) and 013 for knock. AGU relies on MAF readings mainly so if this is off it could be the reason for power loss
  2. schwartza3

    Hi mate, I was reading through some old posts where you were having trouble with the wiring of...

    Hi mate, I was reading through some old posts where you were having trouble with the wiring of the aftermarket horn. I’m having the same issue. Do you remember haw you sorted this out in the end? Or point me to any post? Cheers
  3. schwartza3

    TT / S3 / R32 Steering Rack on A3

    Hi all, Does anyone know if the tie rods and tie rod ends have to be swapped to the standard A3 ones when fitting a TT/S3/R32 steering rack? The TT/S3/R32 tie rod ends fit into the hub from the bottom (vs A3 from top) they can be spun around but doesn’t seem right, it also seems possible to swap...
  4. schwartza3

    Electrical Issue - Cranking but not starting

    Hi all, Just to let you know what the issue was in the end in case anyone comes across a similar problem. It was the ignition switch as I suspected. It is positioned at the end of the ignition barrel. To get to it the steering wheel needs to come off and the plastic around the steering column...
  5. schwartza3

    Electrical Issue - Cranking but not starting

    it's been there last 14yrs haha, no issues I've ordered an ignition switch (the one at the end of the barrel), hoping this may be the problem. Steering wheel has to come off to get it out.
  6. schwartza3

    Post pics of your A3/S3

    hi mate, the lip is from vw polo mk3, side skirts are from mk5 mk5 skirts are a straight fit, the lip needs just a bit of cutting at the ends to fit the a3 bumper. i'll see if i have some close up photos and ill put them up
  7. schwartza3

    Post pics of your A3/S3

    tried the blacked out look for a while and got sick of it - back to polished lips
  8. schwartza3

    Electrical Issue - Cranking but not starting

    Might go all the earth points, anyone know how many there are/locations?
  9. schwartza3

    Electrical Issue - Cranking but not starting

    The fuses/circuit look ok, here is a quick snap.
  10. schwartza3

    Electrical Issue - Cranking but not starting

    Hi guys, Hope someone can point me in the right direction. I've done a few searches but didn't find anything which seemed similar to my issue. Issue: My A3 (AGU) is cranking but not starting 95% of the time When I put the key into start position before firing I've noticed the climate control...
  11. schwartza3

    S3 grill on A3 - Pictures anyone?

    still a lot less than power wasting 4WD system in the s3 though :wink new: A3 all the way!!
  12. schwartza3

    What have you done today?

    built this over the weekend since I couldn't find anything for 8L on the net just gotta paint it now
  13. schwartza3

    What have you done today?

    Installed facelift grill and new lip
  14. schwartza3

    feed wiring through top vent?

    remove the fuse box and you should be able to see a bit better where it's going I had mine coming between the A pillar trim and the dash before placing it on top of the steering column
  15. schwartza3

    Another hybrid k04-023

    Ok, fair enough, explains why the graphs look the way they do, ecu is just guessing how much fuel should be added. In open loop, obviously it ignores the o2 sensor but is it using the maf signal g/s to calculate how much fuel should be added? Might explain why it's dumping so much fuel if it's...