thats a normal a4 with a gmbh front and rear bumper, and s-line and s4 badges slapped all over it. it does'nt even have sport seats.
missing the door flares too
yeah the vents already had the led, run a 9v battery across the led it should light up, the polarity is only one way so if it dont work one way try it the other, but make sure you have this right when finally wireing it up.
i dont understand why andi put the hardware there but dont wire it...
the spring kit is a eibach pro sport coil over with eibach stainless steel dampers, turned up about 8mm from minimum spec, the wheels are et35 too i had the others on the rear as you can see from the pic and the rubber caught the rear arch when and only when the car was...
the old cup holder and coin tray never had built in led's, the new units did, they where removable tho, so i'm assuming you could buy the seperate, i had to solder up the wiring directly to the led's and splice in the units to the esp wireing and run a ground apart from that easy,
heres the techy bit, the reason your car runs worse on 19" compared to 17" and 18" is the wheels rotational mass changes i.e. where the was rubber and air there is now metal, causing a drag on the engine hence the drop in performance and mpg....
so i've been told?
last week the coin holder broke, then the cup holder got stuck, i think it was a xmas gift from the car, :)
the leds on the vents, cup holder and coin holder, i ran off the esp led wire which i ran already got to when i fitted the navi plus, make sure if you guys are doing this you use the...
gave the car a clean today, weather was good and i'm back to work tomorrow so decided to give it a good wash and fit my new cup holder and coin tray, also wired up the leds in the vents and the above bits too....check it!!!..nice
bit sadi to see the old wheels go...:(...
my cup holder and coin tray broke this week, there about 28quid each, vagparts have the cupe holder on there website,
i have noticed on the new ones there are led's connectors on the back, does anyone know where or what the part numbers are for the wireing kit?