Recent content by thebedscompany

no I think he means the square rubber sponge that is stuck to the bottom of the rear lamps int the middle, i think it allows the lamps to squeeze in as tight fit on top of the bumper? I know because i replaced mine today and the old style rear lamps have them stuck onto the bottom but the new...

That bumper is not for a 3dr hatchback it's for a cabriolet

Nigel did you get my email?

Nigel did you get my email

I would be car-full as the valence is glued onto the bumper so if the bumper has no valence possible it been ripped off? look for damage to the top centre bumper clips that connect to the rear bumper trim, trust me got ripped off by someone on eBay. i might sell the double s-line diffuser + got...

Ads I am thinking of doing the same thing even got the sline bumper of 10 plate with double diffuser and grill but serious think that my a3 140 tdi twin tail pipes that point to the ground may not do it justice, got the grills inserts and everything but afraid o what it will look like so...

Nigel my pm don't get delivered to you for some reason can you please PM me your email address

finally Nigel been trying to get hold of you send you loads of PM the only reason i am doing this work, because I have had no reply. sent you a list did you get?

I have the following items and need to install them, i have purchased an audi A3 S-line bumper of 2010 plate with the grill diffuser, i am upgrading my 06 sline a3 rear to the new 2011 style rear i have separate post for the mods coming shortly Thanks to member Ads great post this has been...

HI guys this is a bit off a odd one, i had single beam xenon headlamps on my 3.2 Quattro which have swapped over onto my tdi and replaced them with standard halogen headlamps, however since doing that i have the following error ( headlight range control defective ) i thought maybe it needs...

Hi, if you’re still going to go for a HID KIT conversion look for a genuine set of MTEC-HID KIT specific for Audi a3-a4 there are a bit pricey around £150 but you dont get any interference or power surges to any other electrics on board so no wiper motor issues, plus no dashboard error issues...

thanks for the info all done!

Hi guys just an update the swap was simple all plug and play no harness needed if your converting to single xenon’s, without coding the lights they will flicker and show both low beams out on the dash, however if you can’t code straight away there is away to bypass the system just turn the...

THANK YOU SO MUCH FOR THE INFO C_W will ive it a try in the morning,

Hi mate I need my 2006 Audi a3 coded to xenon, if you can do the job please let me know and the cost, kind regards Nads