My A4 has the towbar fitting but unfortunately is missing the detachable part. I have tried scouring the internet but cannot see to find this part anywhere.
Has anyone got this setup who could share a photo of the missing part?
Or know if they would be interchangeable with other brink fittings...
2008 (08) Audi A4 Avant Sline
Manual 6 speed
Tax: £195 annually
Rear parking sensors
Built in sat nav (rns-e)
Oem Bluetooth hands free
Ambient front interior lighting
Thanks for your reply have been away for a couple of weeks.
Yes it’s actually crazy some of the cars that are driven around with complete neglect. Although in fairness the to rear tyres are actually good tread but have slight damage to the side walls.
It’s a well spec’d with front and rear...
Just got myself a nice B6 avant for a fixer up for my new ‘daily’ unfortunately only a FSI, but very high spec so all good
Anyway onto the problem, so it fails on several brake issues on the rear. So my plan of action is to do discs and pads, and replace n/s rear caliper but maybe both.
has anyone manage to source new mirror icons for the drivers grab handle ?
Mine are worn and appears you can only get replacement with an entire new handle if I’m correct
Photo to show which part obviously not my handle as these are still legiable
Cheers all managed to make good progress! So actually layed on the floor and looked at the pins on the controller and there wasn’t present in 17 (guide said post 07 would use 17 not 13) anyway that was the positive sorted.
I then ran a wire from the battery for a ground a know good one and all...
Still on joy with the front, but got the rears working. Needless to say I need to get the fronts figured before I cut the rears in as that would look a bit silly
Going out now to try with a different earth point
Have only focused on the front passenger so far as had the door card off for replacing the window switch.
I have check the lights / loom on a 12v source so know they are good. Some post about suggest it can take several hours for the door cotroller to reconfigure
im trying to retrofit door warning lights, I have piggybacked the earth in pin 21. But not getting any luck with power, I have tried both pin 13 & 17 but nothing. I’m on a 08 plate with date of March 08 on the controller. I have tried unplugging the harness from the body of the car and also...