Search results for query: *

Good bit of info for anyone else. Cheers

So update. The parts arrived and I have just used the tie rod off the cheap copy and refitted the Audi original. done a short drive and the codes seem to have stayed off so hopefully all sorted. Also fitted a replacement temp sensor for the AC and did the service.

So update. The parts arrived and I have just used the tie rod off the cheap copy and refitted the Audi original. done a short drive and the codes seem to have stayed off so hopefully all sorted. Also fitted a replacement temp sensor for the AC and did the service.

Thanks as always Dippy. I was hoping that might be the case and the fact that the data on each fault is the same in terms of time and count etc. I will let you know when the part turns up and I get it fitted

Cheers for the advice

Can anyone help with the below. I am waiting for the new part to arrive but Im still unsure if I have an issue with the suspension. Cheers https://www.audi-sport.net/xf/threads/vcds-scan-with-electric-damper-fault-adaptive-head-light-warning.438659/

Update on the Update I have managed to get to the car and remove the wheel to find that the arm on the level sensor was snapped at the plastic ball joint. Audi wanted £172 for a new one but I have taken a punt at a replacement for £50 I'll get it fitted and see what happened and if the...

Update. Done a clear 2nd scan and a short drive. I got the same adaptive warning so done a fresh scan and I get the below. Would the level sensor affect the other faults or I'm I looking at the wrong part? 1 Fault Found: 00471 - Control Module for Elect. Regulated Dampers (J250) 013 -...

Hi I have been getting an Adaptive headlight warning on the dash for a week or so. Its not on every drive but does show up most of the time. I have now done a scan and it is showing the below, There seems to be a lot a reference to the Electronic dampers. Would this all be connected and where...

Whats the best way to log the ECU data when doing 1/4 mile runs without having the laptop plugged in using VCDS I did try the Tourqe app but unless I missed something it didn't log the full data. I would to be able to see intake temps and exhaust temps. timing and throttle position. There...

Went to pod today for the first time in the S4 B8.5. Had two runs 1st run got sat on the lights to long and I think the LC didn’t like it so it dropped all revs when I let off the brake 2nd didn’t use LC but going into 2nd the car didn’t rev and took its time to get back in the power. Any ideas...

will take a look thanks

Hi I think my front wheel bearing needs changing but how can I find out what type I have without stripping it down to look. I want to order two from AUTODOC but there is two types mines a b8.5 2014 cheers

Well over the past week I have had the joys of replacing the Thermostat and water pump, I also took the chance to replace the very dirty intercooler rads in the supercharger. While i had the car apart i also installed a dual stacked Jag heat exchanger, I paid £99 for the Alloy Jag radiator and...

Also be careful removing your coolers the ends of them dint easy if you put too much pressure on

I went with. Mahle ones. At about £150 each. Oem where £350. Stock is a problem with most places also when it arrives check the water pipe end is nice and flat. I had one that had a small dent and had to be returned. you may also want new prongs for the water pipe. I got these from Audi...

Not easy if you can’t see the leak. Sounds like the pump but it could be wet from removing the charger. Good luck

update no2. a Quick google and i had the answer I had made the amateur mistake of not opening the flaps before fitting the manifold. Charger off and on again just need to fit the belt and we are good to go. This is the first time i have had to work on the engine other than basic service etc...

So Update. New battery fitted and the missed throttle body cable Doh, That what happens when trying to do it of an evening after work . the car now starts and drives but I do have a message saying intake flap bank 2 stuck closed. I have done a vacuum test and it is connected and i can hear...

Thanks pal. I’ll sort the battery and then see where am at.