Search results for query: *

UPDATE I contacted Darkside Developments to ask for their expert opinion on my issue. Please view their response below. Now I'm totally confused as VCDS says there is a swirl flap problem. Also is the throttle valve easily accessible to clean ? I wouldn't have a clue where to look once the...

Hi everyone Just recently my engine feels like it is miss firing when the throttle is held steady at a constant speed. It doesn't happen all of the time and there are no warning lights on the dashboard. It has done it occasionally when parked up without moving. I've scanned it with VCDS and it...

Hi all. The engine management light came on yesterday on my A6 C7 3.0Bitdi, after scanning with VCDS the following fault codes are displayed. Can anyone help with a solution to resolve please ? Thanks in advance. Dave Address 01: Engine (J623-CGQB) Labels: Redir Fail! Part No SW: 4G0...

All fixed now. Dried the cluster out thoroughly with a hair dryer then left on a radiator over night. Made a new foam seal and run a bead of clear silicone around the leading edge to hopefully eliminate water ingress. Finally cleared fault codes via VCDS and rescanned. All good so far :thumbs up:

I take it from the VCDS report the fault lies in the light unit and can't be fixed ?

Hi everyone. I've got a faulty rear nearside indicator LED stiprip on my A6 saloon. The faulty cluster is on the boot lid and affects a single line of LED's (see attached photo). The rest of the LED's in the cluster are working. I've attached the scan from VCDS for the affected module. Any...

Hi all Has anyone had this same issue please? I noticed the engine management light come on this morning on my 2014 A6 3.0bitdi on the way to work and a considerable loss of top end power with the engine unwilling to rev freely at the top end of the rev range. Scanned with VCDS and the two...

Hi all Has anyone had this same issue please? I noticed the engine management light come on this morning on my 2014 A6 3.0bitdi on the way to work and a considerable loss of top end power with the engine unwilling to rev freely at the top end of the rev range. Scanned with VCDS and the two...

Ah ok, thanks for getting back to me. Does anyone on here know how to do it on vcds please?

Hi How did you switch the default stop/start to off on vcds please? I would like to do the same mod.

Thanks Shaun Apologies again for the inconvenience.

Sold Ricky

Pm'd you Shaun.

PayPal ok?

Crewe, Cheshire or can post for around £10

No, no damage, photo was taken with a bedroom light on. I've taken another with a different angle to show no damage to it. lights are plug and play with no errors on vagcom/vcds or warning lights on dash. Hope this clears up your concerns.

More pics here, sorry for delay, been working nights.

Yes they are Shaun

No issues with 'bulb out' with these, they are plug and play. Unsure of make, just know they are good quality after market lights.

Sorry for the very late reply , only just seen your post. Yes they are LED. Unfortunately, I don't have any more pictures as I've sold the car now.