Search results for query: *

  1. D

    Reverse Sensor Fitting - Drilling point?

    I'm trying to fit some reverse sensors to my 2004 A3. I've taken off the rear bumper, but the bumper doesn't have the little crosses that I've heard about where you're supposed to drill. Any advice on how I can drill the holes in the right place? Thanks
  2. D

    Help removing rear bumper / Nuts in holes

    I'm removing the rear bumper on my 3door, and I've got every screw out except for the 2 nuts that are in the holes in the boot. How the hell do you get theses out? No tool I have can get in there to undo the nut and all my sockets get stopped by the ridiculously long screw. Any ideas? Thanks
  3. D

    2.0 TDI Rough idle only when warm

    If the CTS would bad, would my oil temp gauge on the dash show a wrong reading?
  4. D

    2.0 TDI Rough idle only when warm

    Is there any way I can check if the sensor is defective without replacing it? Although I don't mind paying since they're only around £10
  5. D

    2.0 TDI Rough idle only when warm

    Yes the fuel filter was changed and I had the injectors cleaned. The car also suffers from the warm start issue. Could that be linked to the rough idle?
  6. D

    2.0 TDI Rough idle only when warm

    My EGR has been blanked (after the rough idle developed) so I don't think it's that. Anything else I should check with VCDS?
  7. D

    2.0 TDI Rough idle only when warm

    I've got a 2004 2.0TDI (BKD Engine) which runs fine when the engine is cold, but develops a very rough idle when the engine has warmed up to around 90. I don't think it's the DMF as the roughness doesn't change as the clutch is pressed in. I've just changed all filters and oil, which had no...
Top
Back