Search results for query: *

Cheers for the reply Steve, I wanted to know the answer to the original question as I seem to have an intermittent fault on the anti shudder valve and when I looked at it I got the same readings as ukaudi. My problem is that the glow plug light flashes on and off and I can actually feel it kick...

Thank you for your over welming replies.

Any chance of one of the Vagcom guru's answering this question as I have the same issue and it is buging me. My car is a Audi A4 avant 2.0TDI 170bhp. Also I have used a vagcom unit and cannot do a output test on the throttle body/anti shudder valve as the option to do a certain part/unit is...

Once it turns up yes and when I get a moment free I will locate it and let you know.

Yes i did and it was the same. I went the car this morning and all was fine and has been since. I did some research and it looks like a fault fuel pump relay which I have bought another one and will fit it if or when it fails again. Cheers Rick.

Hi all, I've just drove home pulled on the drive went inside for about 20 minutes went back out to go pick my daughter up and the car just turns over but will not start. It does fire on the turn of the the key or a fraction of a second then nothing almost as thought it is immobilised anyone had...

Cheers laruk It is a diesel and I have been researching this and I've seen that the cooling fan fuse is mentioned so I will be having a look tomorrow if I get a chance.

The code I got from a cheap audi scanner was 012546 and this is what ross-tec says. The highlighted comments are what I'm going to do or have done already. 19558/P3102/012546 - Motor for Intake Manifold Flap (V157): No Signal Possible Symptoms Hard Shudder when turning OFF the Engine...

Hi All, Does anyone know the location of the above fuse as I can't find it and I have a fault showing. I have taken the EGR and this manifold motor off and cleaned them both (they were not bad) but I think the motor is not getting any power so I want to check the fuse but can't see any...

The brake pad carriers can get worn or some pads are slightly smaller which causes a clunking sound which is more noticeable at lower speeds. I have noticed this on motorbikes I have worked on in the past as the sound is more noticeable as you are sat above the calipers.

Thanks NHN, There is a lot of helpful advice and people on here. Cheers Rick.......

We had another go at this over the hols and managed to get rid of the error 22 some how not too sure what happened there. The only differences were that I have earthed out pin one at the back of the clocks to get rid of the low screen wash warning and also I had removed the rear wiper motor as...

Morning All, I have fitted the cruise and dis stalks to my 2006 A4 avant s line with multi function steering wheel and with Mike Fosters help (thank you) we managed to enable the dis function and I earthed out pin one to get rid of the washer level warning which is great. The problem I have now...

Cheers all, I just kept seeing it mentioned and was interested.

I did that and it did not make it clear.

Excuse my ignorance but I keep seeing the reference DTM I know it must be a model of Audi but what does it mean??

i have fitted them both and I think I could sort out the cruise it's the dis I'm not sure of. Cheers Rick.

Cheers all for the reply, @udi A3 cheers for the offer Im bit stuck on time at the moment that's why I hope'd someone local could help. As a guide how much should it cost me. Cheers Rick.........

Cheers Andy27168, I think if there is anyone local I will see how much it costs to do as I don't want to make a mistake trying it myself. The cruise looks simple and I can get a vagcom to use but the lack of info on Dis makes me nervous. Cheers Rick..............

Like I said similar, basically half the question answered :-) Ok are there any Vagcom guy's around the bradford area that can enable the Dis and Cruise stalks that I have fitted. I will run the wire from pin one myself. Cheers Rick......