Thanks Mate, is that an option on the first page when you go into the module, where I would have selected coding ?
car is in bits at the moment and the battery is disconnected.
Paul
I'm in Warsash and will be at home working on my own car in the morning if you want to come my way for a scan.
If you are free in the morning PM me your contact number and I'll give you a ring with details.
Paul
I have emailed the Ross Tech support department for some assistance, just trying to understand things a bit myself.
Tomorrow I will be retro-fitting the Bluetooth KIT 7P6035730F module in my MY12 Skoda Octavia VRS.
In preparation I have had a look at the CAN bus coding as I believe I will need...
That was my thoughts on the subject, the Central Electrics module must send a small pulse across each bulb to check the continuity, on the leds this give you the pulses when you power up.
Apart from that they do look good enabled.
Paul
Also I always do an autoscan and save the log before I do anything on any car, that way you
a) know that there aren't any fault codes before you start
b) have a baseline of coding for all of the modules to refer back to.
Regards,
Paul
Here is the coding from my 2005 (05) 2.0TDi, DSG S-Line, it might help you.
Address 03: ABS Brakes Labels: 1K0-907-379-MK60-F.lbl
Part No: 1K0 907 379 K
Component: ESP FRONT MK60 0104
Coding: 0023174
Shop #: WSC 06435 000 00000
Slightly newer version than yours, I...
Met up with STampie on Saturday and coded up his lights OK, only slight issue we had was that the LED rings would flash 6 times (when you switched the ignition live) if we left the setting Byte 19 Bit 2 Cold Diagnosis rear active if we switched it off it didn't do it.
His instructions seemed to...
I believe that the cold diagnosis is basically a start up check of the bulbs - and that you will still get a bulb failure if you turn it off when you turn the lights on.
Now it is a PITA if you want to fit LED replacements, but it is a fantastic warning system.
Paul
Just wondering here - but is that not suggesting that there is an issue with the steering Angle sensor for the value to be that high ?
Not looked at what is involved with changing the rack - but if the value should be between +/- 1.5 degrees and yours is reading 5.25 it would suggest that the...
Hi mate,
Don't have the gearbox code but it is a 6 speed manual engine and ABS As below :-
Address 01: Engine (CBB) Labels: 03L-906-022-CBA.clb
Part No SW: 03L 906 022 FD HW: 03L 906 022 BQ
Component: R4 2,0L EDC G000SG 3613
Revision: 13H01--- Serial number...
Right Phill came round last night and I was able to code his ABS to enable TPMS.
He now gets the TPMS warning light show with the rest of the warnings when you turn the ignition on.
However the button doesn't seem to work, I can't see it activate in the ABS measuring blocks and it doesn't...
Thanks for that :slap:
I appologise for wasting your time Sebastian, seeing that message for the first few bytes and my google search not finding anything on the subject of Long Coding on the ABS module - caused me to back out of it and wait for clarification.
Even though I had a full scan I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.