Search results for query: *

Anyone know where I can see documentation of the recall information in order to have proof for the switch at my garage?

Can you direct me to the thread, please? Is there a legit form expressing the recall that I can show the garage. There are only 13 S3 in my country. Thanks!!

I recently heard that there was a recall on the coils. My car still has the original coils and perhaps they are causing my engine misfire. I can find no posts on the issue of the coil recall. There used to be threads on this issue but no longer. Can anyone direct me to where there is...

Thanks guys

The car has been on the road since July 2007. Here it is considered a 2008

Sorry, but not under warrantee. I guess it could have been a fluke. If the starter starts going than the symptoms are consistent? In other words, it will continue to give me problems every start? Thanks

The car is a 2008 s3 running on 98 octane with 22000 km. When cranking it it doesn't sound slower. Thanks for the quick reply.

Could someone tell me how to diagnose starter motor problems. Today when trying to start in the morning the starter turned a few times and stopped. I turned the key back and then forward and the car fired like normal. It is a possibility that I let go of the key too soon, but I think I that...

The Cs look the s**t. What do you do with the back seats to make a nice fit?

I might be able to pinch a whole set here in Israel for a pretty pound off a 2008 S. Do the buckets have air bags? Is it is a problem putting them in? Will the airbag light go on?

somebody has to know

O.K. but what is the stock height from hub to fender?

Could someone please tell me the stock height from ground to center hub or center hub to fender. I just installed kw coilovers and didn't check the original height before installing:banghead::banghead:. How low can I lower the car without any rubbing whatsoever on 18" rims? Thanks

It is the stage 3 endurance APR - High Performance Development for Audi, VW and Porsche Vehicles.. It states that the flywheel is low carbon Stainless Steel. Regardless, on these clutch setup systems is more gas needed to start in first to keep the car from juddering.

I'll get back to you as the type of flywheel

I have noticed that when engaging my clutch in first gear (dxd stage 3 with flywheel) it takes more pressing of the gas pedal for it to start rolling without a judder. I have 1500 km after installing the clutch and stage 3 apr. It may have been this way from the after the installation and I only...

If you mean are they balanced on a machine that spins the wheel while off the car than the answer is yes. No other way to balance here.

The story starts with my car 2008 S3 with stock rims and stock tires (michelin sp3; rims18/7.5/54 offset) My car (APR stage three) was looking anemic so I thought I'd deck it out with new rims (Lenso 18/8.5/42 offset) and Toyo R1R. To my dismay the steering wheel started shaking at 140 km/h. I...

Mike thanks!! Is the grommet on the underside of the car or under the carpet?

The water doesn't seep into the floor and rot it? It doesn't get trapped in the panels under the carpet? What is a "floor grommet?"