Hi guys,
I wrote the same message to Djalix but i think that is correct share any info with you (and maybe someone can help me!) . So, I've searched through a lot of posts in this forum about this topic but I can't find what i'm searching. Briefly I have an A3 spb 1.6 my2013, VCDS 16.8 and i'm trying to activate the Auto-Hold function.
I cannot find in module 03-ABS the adaption "AUTO HOLD functional status" (to be set on "always active") and if I try to change the following byte of the long coding, the module refuse the code.
Byte 08 = 03
Byte 19 = C0
Byte 23 = F7
Byte 25 = 43 (manual transmission)
Can someone help me?
Ciao
Mattia
I wrote the same message to Djalix but i think that is correct share any info with you (and maybe someone can help me!) . So, I've searched through a lot of posts in this forum about this topic but I can't find what i'm searching. Briefly I have an A3 spb 1.6 my2013, VCDS 16.8 and i'm trying to activate the Auto-Hold function.
I cannot find in module 03-ABS the adaption "AUTO HOLD functional status" (to be set on "always active") and if I try to change the following byte of the long coding, the module refuse the code.
Byte 08 = 03
Byte 19 = C0
Byte 23 = F7
Byte 25 = 43 (manual transmission)
Can someone help me?
Ciao
Mattia