Does anyone have ready access to an a\c compressor - or the pulley more importantly?
I would greatly appreciate the measurements between the centres of the 3 holes around the centre nut\head\shaft. The approx diameter of those holes would be great too. I've seen tools that are used with an impact driver that undo the drive plate, that have 3 prongs that engage with those holes.
I'm hoping with the measurements and an hr or so in the workshop - I can bodge something up that should work. But this grand idea came after the unsuccessful attempt to remove the pulley on the pump and putting everything back.
Cheers
Dibs
I would greatly appreciate the measurements between the centres of the 3 holes around the centre nut\head\shaft. The approx diameter of those holes would be great too. I've seen tools that are used with an impact driver that undo the drive plate, that have 3 prongs that engage with those holes.
I'm hoping with the measurements and an hr or so in the workshop - I can bodge something up that should work. But this grand idea came after the unsuccessful attempt to remove the pulley on the pump and putting everything back.
Cheers
Dibs