Draining the tank. S3

[R0cket]

Is there a way with vcds to make it transfer the “other side” of the tank over?

in engine on output tests I activated the fuel pump and drained it down to 1/4 on the gauge but now it’s stopped and I can only assume the passenger side of the tank still has fuel in it.

i wanted to drain it because it’s been sat for 2yrs and I’d rather put some fresh v power in now it’s back on the road

edit: in instruments I have the measuring blocks fuel sender 1 and 2. Both are reading 0.0L, but the gauge reads the start of the red...

 

[R0cket]

Weirdly now my gauge is reading empty. Must of been the cycling of the ignition or something that zero’d it

 

[NHN]

Remove rear bench, remove pumps & check with a torch.

 

[R0cket]

Pretty sure the tank is empty now so using the output test must transfer it from 1 side to the other. New fuel filter and some fresh v power tomorrow. Cheers.