Finally managed to fit my Thinkware F770.
Routed cables through the roof to back of car, one cable into tailgate for rear camera, one cable to rear power in boot. I first tried going down the A post but didn't like the fact that there is an air bag and it might hinder operation, and I couldn't get trim off.
As I had to get one cable to back so 2 didn't make any difference.
After I had fitted all I did notice that the DAB kept going in and out of signal, mostly out.
I had already fitted ferrite rings to the power so was not sure what to do.
I new that the interference was from leakage from a power cable but I had already covered that ?
Then I realised that the rear camera must have power so I put ferrite rings on cable at front and rear of rear camera. Sorted, tested last night and never lost signal once.
Routed cables through the roof to back of car, one cable into tailgate for rear camera, one cable to rear power in boot. I first tried going down the A post but didn't like the fact that there is an air bag and it might hinder operation, and I couldn't get trim off.
As I had to get one cable to back so 2 didn't make any difference.
After I had fitted all I did notice that the DAB kept going in and out of signal, mostly out.
I had already fitted ferrite rings to the power so was not sure what to do.
I new that the interference was from leakage from a power cable but I had already covered that ?
Then I realised that the rear camera must have power so I put ferrite rings on cable at front and rear of rear camera. Sorted, tested last night and never lost signal once.