FMIC AUDI A4 B6 1.8T 20V PASSAT TURBO INTERCOOLER KIT | eBay
Good for 300bhp
easy fit, comes complete, no hassle to fit, just bumper off and a bit of plastic trimming.
issue is the space between crash bar and rads.. You won't fit much more in there really. 2.5" pipe would be nice but hey
The thing with those kits is the amount of trimming required to make them fit,it's one of the reasons I haven't bought a front mount yet
That's a nice setup you have there, is that a FWD 2.5 tdi ?Get your hacksaw out.... and your welder to make the ic support frame and dont forget to put a bead arround the pipe ends to stop the hoses blowing off if you up the boost pressure
Think it was 10 hours give or take but we mocked it up so that saved a lot of time
So you're saying that a GTB1759vk hybrid will support 300 Bhp ? I somehow doubt it, 250-270 yes, 300 is hard work even with GTB2260Vk...3" pipe work cannot remember but 450 x 300 x 60mm rings a bell, stock turbo converted to hybrid turbo by Adam at Tdi turbos in Poole, internals upgraded with 59mm compressor with custom tips and brand new bearings
Oh ok. Apparently the ko3 tip will still fit over the bigger housing aslong as its not a forge one as there to well built and strong lol that's another thing I need but don't want it to cost me the earth. What did your friend do to make 245 bhp?
It will fit any car with a little determination ! However, intercoolers are not really required on a tdi unless you're running in excess of 250 Bhp. I run a 300 Bhp v6 , 2.5 tdi on a factory FMIC, it's off a allroad tdi and it's full alloy !Thread resurrection.
I don't suppose this would fit a 1.9 tdi?