Parts for my A3 Saloon

Henda

Registered User
Hi i have an A3 saloon sline 2016 1.4tfsi (COD) , i am after a set of 8mm hubcentric spacers. I only require two extended bolts if you sell them individually, with a radius seat.
Can i also get a price for some Eibach pro line springs please.
If your still based in the north east i can collect.
 

Henda

Registered User
Hi Damian,

i am just after the one set of 8mm for the front. Have larger spacers on rear already, if you sell radius bolts individually i would take 2 extended bolts also if the spacers didnt come with any.

my car has the independent rear suspension

thanks
 

Henda

Registered User
The spacers come with a full set but we can just send x2 and reduce the price.

H&R 8mm spacers with only x2 bolts - £75.00 inc. VAT
Eibach Pro springs - £192.05 inc. VAT

Damian @ DPM Performance
Hi Damian

thanks for that, i have miscounted the number of bolts i need and i require 4 not 2. How much would this be. And how quickly could you get them to me. Or i could collect today?

thanks
 

DPM

Site Sponsor
Site Sponsor
I can pay either i dont mind. Which ever you prefer

Ok for card payment you'll need to call us on 0191 2816844, for Paypal we just need your Paypal email address and for transfer we can PM our details.

Damian @ DPM Performance
 

Henda

Registered User
@DPM Do you have them in stock. As i just tried to order a set from a garage that was gonna install them but eibach said there are on 5 week back order
 

Henda

Registered User
@DPM i went to fit the 8mm spacers to my car today, the spacers sits on the wheel hubs fine but when i offer my wheel up the centre collar on the spacer is preventing my wheel going on fully leaving approximately a 3mm gap between the back of the wheel on the front of the spacer. Which obviously isn’t right, are you aware of any issues?
 

DPM

Site Sponsor
Site Sponsor
@DPM i went to fit the 8mm spacers to my car today, the spacers sits on the wheel hubs fine but when i offer my wheel up the centre collar on the spacer is preventing my wheel going on fully leaving approximately a 3mm gap between the back of the wheel on the front of the spacer. Which obviously isn’t right, are you aware of any issues?

Do you have spigot rings fitted to the wheels?

Damian @ DPM Performance
 

Henda

Registered User
I am in between night shifts at moment and with the weather outside it would have to wait a couple of days.
I have offered the spacer up to the back of the wheel and the two faces don’t sit flush together, the actual centre bore of the spacer slides inside my wheel bore without issue its a perfect fit. Its the chamfer on the spacer fowling on the chamfer on the back of the wheel. Its as though they are not the same angle.
Some one on the fourm mentioned that h&r do different angles on the chamfer on the front of the spacer can you confirm this is correct or not. Had numerous sets of h&r spacers over the years and never had any issue.
i run 12mm h&r on the rears and not had any issues with them.
 
Top