What did you do to your audi today

[feva]

View attachment 155176 Painted my brake calipers today
View attachment 155173 View attachment 155174 all in very happy look alot cleaner hardest part is removing plastic wheel nut covers found the secret way which i wont post

Was it the tool in the boot

Half a job, what about the shields behind the disk?

Like this

Sent from my Note 8 using Tapatalk

 

[Marky007]

Was on quick timescale had to pick my daughter up but paint was still wet wen i needed to leave so used my van. . . .

 

[Sippo]

I had to buy 4 new centre wheel caps because some scumbag stole one.

 

[Marky007]

I had to buy 4 new centre wheel caps because some scumbag stole one.

Where did you get them from may need some myself

 

[jdp1962]

Where did you get them from may need some myself

@Marky007 , check out this thread to identify the wheel fitted to your car; you'll also find a note of the part number for the corresponding centre cap. Once you've got that, use our Parts Request system to get a quote.

 

[Sippo]

Where did you get them from may need some myself

http://www.amazon.co.uk/gp/product/B00LDT0WVY/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1

Ok in quality. Obviously not as good as OEM but I am did not want to spend a lot on just one!

 

[Marky007]

http://www.amazon.co.uk/gp/product/B00LDT0WVY/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1

Ok in quality. Obviously not as good as OEM but I am did not want to spend a lot on just one!

You got a pic with them on wheel

 

[Sippo]

Not the best photos and my wheels are filthy! 1st one is OEM, 2nd is the one i bought.

 

[Sippo]

Hope that helps. They are the same colour and you really couldn’t tell the difference by sight only.

 

[Marky007]

Hope that helps. They are the same colour and you really couldn’t tell the difference by sight only.

Yeah they look great .

I was looking at these on ebay

 

[Roadrunner146]

Just managed to get mine remapped. With the supercharger pulley reduction, I should now have, fingers crossed. 450 horses under my right foot. An increase of 160bhp.
I am going to have to be very careful.

 

[kettle]

Just managed to get mine remapped. With the supercharger pulley reduction, I should now have, fingers crossed. 450 horses under my right foot. An increase of 160bhp.
I am going to have to be very careful.

Very jealous! Don't think I can wait till my warranty ends to get mine done. Need to join the 400 club

 

[Chipmunk73]

Am just in 400 club courtesy of unicorn .. i installed a revo intake last week and bcs exhaust should of gone on tommorrow but got told it been delayed because of my zirotec tips
Next sat now.. so put an sos to unicorn about next stage with pully upgrade dsg msp done already can see the next few years getting expensive lol . Soon be with you roadrunner

 

[Hellz]

Today I fit a K&N high air flow filter, forge intake, drilled the airbox and got booked in for stage 1+ next Friday - just in time for bank holiday weekend

 

[Rich76]

Have the car a good clean !
Poor boys black hole then nattys blue!

Plus a Coat or polish on the wheels

 

[countwilliam]

New exhaust from Powerflow Mitcham, I’m one happy chappy!

Sent from my iPhone using Tapatalk

 

[Chipmunk73]

New exhaust from Powerflow Mitcham, I’m one happy chappy!.. looks awesome ik the feeling just had my powervalve fitted and the farts are worse than my wifes

Sent from my iPhone using Tapatalk

 

[SRRAE]

Tried to change the thermostat. I got the old one off and tested it. It was opening at 69C instead of 82C.
Tomorrow?
Trying to put it back on

 

[Hellz]

Got some new pressed plates and surrounds.

 

[Cerbera9]

Snapped the head off one of the supercharger bleed screws..........what a pain to sort!

 

[Deo]

Changed passenger side front wheel bearing on my b8 s4 today. Also had remap done yesterday

 

[Chipmunk73]

Was it done on dyno? Any results Deo?

 

[jdp1962]

Got some new pressed plates and surrounds.

Nice job; got a link to the supplier?

 

[Deo]

Was it done on dyno? Any results Deo?

Didn't have a dyno done, but I will. It was done by a company called ecomax in Peterborough. Estimated gains 60-70bhp. I'm happy with the way the car feels and drives, can't be bad for £299. I can't justify the prices for revo etc Not just for a remap anyway

 

[Hellz]

Nice job; got a link to the supplier?

I'm assuming you mean for the surrounds mate. I got them from eBay - https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.co.uk/ulk/itm/183144925203

Delivered quickly and seem well made.

 

[Hellz]

Can share the pressed plate provider too if that's what you're after

 

[jdp1962]

Can share the pressed plate provider too if that's what you're after

Actually it was, but a few minutes after posting, I found this site and placed an order.

 

[Chipmunk73]

Changed wheel nut covers and centre cap to black

 

[Hellz]

My new EBC red stuff pads arrived today - not fitted yet though, this thing needs better stopping ability now! Hope these do the trick. .. will try and get them fitted in next few weeks

 

[Chipmunk73]

Luvvly jubbly

 

[Chipmunk73]

Just got an import duty letter off parcelforce .. my boot spoiler been tagged from china no pay up no spoiler lol .. had loads of bits and bobs from china but never no tax .. is there a limit on ££ or just unlucky?

 

[Cerbera9]

Fitted Methanol injection system to the S4 to keep those IAT’s in check this summer

 

[forty3]

Removed lots of parts to take to the bodyshop tomorrow.

Turns out that the mirror covers are a proper nightmare to get off!

 

[Chipmunk73]

Waited 6 week for a yummy ducktail from china .. must say it fits like a peach and dont think ide of got any better from ecs

 

[Stephen Payne]

Fitted a nice pair of Pirelli p zero yo the rear.

 

[Deckard]

034 gearbox & diff mounts fitted this week, thumbs up for this mod.

 

[Jamie B D]

Waited 6 week for a yummy ducktail from china .. must say it fits like a peach and dont think ide of got any better from ecs

Hey, could you send me over the link for the dovetail please. Looks great, lovely car.
Thank u

 

[Chipmunk73]

https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.co.uk/ulk/itm/282673753870

Dovetail link

 

[Jamie B D]

Thank you mate

 

[IRONy_MAN]

Today I ve activated the cornering lights(fog lights) reversing side mirror and to remember the initial position,parking display so visual not just acoustic and disabled the start stop.I ve had previously done the needle check plus other bits and pieces. Cleaned the windows as well using Meguiars glass cleaner and that s all for today. Adrian