- Joined
- Feb 21, 2017
- Messages
- 2,076
- Reaction score
- 1,232
- Points
- 113
I am keen on adding stitching and aluminum inlays to my doors and I have found a booming market for interiors on eBay (not really sure how entire interiors are available to buy but anyway not the point of this post!
I have hunted down a PFL Sportback 4 doors and center console.
There are two parts to this question... would the entitre door cards just fit from the PFL to FL? (I am guessing the front doors will be fine but would the rear?)
And if not would just the handles and inlays be the same?
The only issue I can see with the console is the USB which I don’t have in the middle but I don’t see why I couldn’t come up with a way to fill that gap... (Even if its fitting a blank USB not connected to anything else).
Will my plan work?
On the Alu inlays did the PFL have the lights in the doors trim too? (Like the FL).
I have hunted down a PFL Sportback 4 doors and center console.
There are two parts to this question... would the entitre door cards just fit from the PFL to FL? (I am guessing the front doors will be fine but would the rear?)
And if not would just the handles and inlays be the same?
The only issue I can see with the console is the USB which I don’t have in the middle but I don’t see why I couldn’t come up with a way to fill that gap... (Even if its fitting a blank USB not connected to anything else).
Will my plan work?
On the Alu inlays did the PFL have the lights in the doors trim too? (Like the FL).
