First work out if you have adaptive xenons, what part numbers are the lights
I fitted a pair of OEM Bi-Xenons
I used this loom
http://www.kufatec.de/shop/product_....html/XTCsid/3ff8579fab64b324299d2c848a4e7522
After the install I ended up with the following operation, think its because I had halogens before and how the wiring loom works but my lights work as follows:
Side lights - small side light on
Dip beam - xenon lower shutter
Main beam - xenon lower & higher shutter and DRL
Main beam flash (no other lights on), only the DRL light.
http://www.audi-sport.net/vb/showthread.php?t=59877&highlight=xenons
As NHM NNH NHN even as said the next issue is washers and leveling. Your new bumper will have the holes for the washers but you will need to buy the pump and piping etc, I dont want to start a debate about the washers but I havent fitted any and not sure if I plan to even though I have the washer jet plates in my bumper. If i get any issues with washers at MOT time I will have to reconsider.
Regarding the autoleveling - I have not fitted the auto leveling kit. i have adjusted the beam left and right to MOT spec with the adjusters on the lights BUT I cant get the height adjustement up any more, it did move an inch or so but not enough. I put the A3 on the beam setter at work and still think there about 3 inches to low.
I need to work out if I can put power (if so what power to which pins etc, I think theres three wires to the adjuster) to adjusters to move them up then I will have more adjustment with the manual adjusters. The kufatec loom doesent link the old adjuster wires in the old plug to the adjuster pins in the xenon plug. As I still have the adjuster in the car I may be able to link the two.
Question for benskin07
Can you confirm if you have adaptive lights or not, if you don't can you tell me how many wires go to each adjuster in the light and take some pictures and I can then compare to my old halogens (I cant easily get to mine without removing the bumper again)
If all else fails I may have to take the lights out again and try and wind the motors up