mattandrew
Registered User
After 6 weeks sitting in the shed, the weather was good today so finally decided to get the spoiler fitted.
The best place to get a splitter is form the Seat dealers as its cheaper that ebay Cupra R front splitter - 1ML 805 903 - £17.95
Firstly I trimmed the two middle legs as they were to long and also trimmed the tops of all the lugs with a stanley knife as they were about 1mm to high as this would have caused a gap between the splitter and bumper. I also cut a couple of V's out of the end of the splitter to enable the splitter to fit to the curve of the bumper. I positioned the splitter on the car and put a couple of self tappers in the middle. I stood back and realised the middle legs didn't line up with mine so had to adjust slightly. I then drill and screwed the splitter at various points around the splitter and finally cut the ends of which were to long.
Most people wount notice but me been pickey I do but the splitter could have done with been a bit further back as you can see the top of the plastic
Some people may prefer the splitter further back or even further forward but think it looks about right, what do you think
The best place to get a splitter is form the Seat dealers as its cheaper that ebay Cupra R front splitter - 1ML 805 903 - £17.95
Firstly I trimmed the two middle legs as they were to long and also trimmed the tops of all the lugs with a stanley knife as they were about 1mm to high as this would have caused a gap between the splitter and bumper. I also cut a couple of V's out of the end of the splitter to enable the splitter to fit to the curve of the bumper. I positioned the splitter on the car and put a couple of self tappers in the middle. I stood back and realised the middle legs didn't line up with mine so had to adjust slightly. I then drill and screwed the splitter at various points around the splitter and finally cut the ends of which were to long.
Most people wount notice but me been pickey I do but the splitter could have done with been a bit further back as you can see the top of the plastic
Some people may prefer the splitter further back or even further forward but think it looks about right, what do you think