Hi
I want to lower my B8 40mm all round but I have a few questions I can't answer and wonder if anyone can assist?
How do I find out if my factory fitted springs are Linear or Progressive?
Has anyone had issues removing bolts in the front, if so, how much of an issue was this and what extra...
Hi
Just after some recommendations / personal experiences you guys have had installing anything to lower you A4 B8
I have a TDi Quattro and want to lower 40mm all round
Cost is not my issue at the moment, I just want to lower her in the best way without losing too much comfort
Coilovers seem...
Thanks
Would coilovers be better long term?
Im not fussed about the cost of either, I just only want the job done once so happy to go coilovers if it has more benefit/more comfort than springs...
Yeah i know it will vary im just after a rough estimate so i can plan to keep within budget this year.
More after recommendations for someone to carry out the work
Hi guys
Just after some advice/information/recommendations
I have just purchased:
Coilovers (To lower 40mm all round)
Brake discs and pads (Drilled and Vented)
I want to get all changed at the same time as it makes more sense than 2 trips to the mechanic, however...
Does anyone have any...
Car: Audi A4 B8 (2010)
Model: 2.0 Diesel TDie (136)
My clutch bearing has recently started to make a "scraping" noise but only when the clutch pedal is fully pushed in, there is no noticeable other issues, and no matter how hard or soft I drive her it makes no difference, the noise is more...
All the files you need are here, if you scroll down the article it details the steps in clearer english, let me know how you go
http://cartechnology.co.uk/printthread.php?tid=2415&page=3
Has anyone attempted to this update themselves or do i need to go to Audi and pull my pants down?
I've got all the necessary files and some "instructions" if you will, but don't want to **** my navi up
Any response/advice would be greatly appreciated
I haven't experienced that yet and recently went on a 400mile round trip without issue
When i originally phoned Audi for the quote on replacing the sensor they said the pricing included the part, labour, calibration and forced regen
The only other advice i have had is when i remove the old...
Car: Audi A4 B8 - 2010 - 2.0 TDie
Recently the engine management light has appeared on my dashboard, i have scanned with VCDS, the result:
Address 01: Engine (J623-CAGB)
2 Faults Found:
5262 - Diesel Particle Filter; Differential Pressure Sensor
P2454 00 [168] - Short to GND
MIL ON -...
If your adding a subwoofer, you could run a feed off of the existing speakers to get audio to the subwoofer, it wouldn't be recognized on the MMI this way but you can use VCDS to add the subwoofer option; not sure how well this will work though as the option controls the cabling from the MMI to...
Depends how much room you have under your seat and what cabling requirements you have
An under seat/flat subwoofer can cost from £30-40 but if you dont have a stock sub then you need to get an amplifier, power, ground, remote and speaker cables, could be done for around £120 i guess
If you...
Go in the boot and look up and see if there's a hole already there, can't confirm about the wiring, and I would check you mmi has an option under sound for a subwoofer.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.