thought I would do a quick write up for the iabed uprated rear main crankshaft oil seal as no one seems to have done on the ea113 engine and have been asked lots to do a write up when I next did one
it is also the same to fit the standard genuine seal except not putting sealant on the face that...
I’m looking for some information on which 2.0T FSI crankshaft to buy for my build. I’m a little bit confused and keep getting conflicting information on which part number or engine code to go for. I want to get a forged 92.8mm stroke crank and I have always been under the impression that any...
Swapping 1.8t engine out of a CVT B7 into a B6 Quattro and have read that there can be differences in the cranks between Automatic and Manual cars.
Both engines codes are BFB so was hoping that they would be easily interchangeable.
Uprated ECS clutch (below) going in so flywheel will be changed...
I have recently fitted a pd130 ASZ engine into my Audi A3 replacing the pd105 BXE engine as this had spun a shell and seized the engine.
The only problem now is it will not start as the crankshaft sensor if different, I can get the engine started by spraying a fuel substitute into the inlet...
Hi,
I've got a '97 A3 8l 1.6 which recently got an issue where it would drop a couple of RPM's while running warm. It would mid-drive drop rpm and shock.
When warm it would also stall when running idle.
Reading it out with vcds it gave me a G28 sensor issue. So I bought a no-brand sensor off...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.