Sam_
Down under
It's probably one for Andrew/Tuffty/Stacey/Scullies etc but what's the best solution for coolant lines, fittings wise for a big turbo 1.8T. I'm hopeing to run the surge housing (4" intake) and will be running a TSR setup.
I assume at least I need the AN adapters for the bulkhead (to run lines around the TIP as per Stacey) and possibly:
- Coolant temp sensor housing with AN fitting (only seen billet ones?)
- Hard line with AN fitting
I've seen a few bits here:
// Machined Parts |
and Staceys post for reference:
http://www.audi-sport.net/vb/a3-s3-...elated-yo-yo-build-thread-34.html#post1856810
Any help appreciated!
I assume at least I need the AN adapters for the bulkhead (to run lines around the TIP as per Stacey) and possibly:
- Coolant temp sensor housing with AN fitting (only seen billet ones?)
- Hard line with AN fitting
I've seen a few bits here:
// Machined Parts |
and Staceys post for reference:
http://www.audi-sport.net/vb/a3-s3-...elated-yo-yo-build-thread-34.html#post1856810
Any help appreciated!