Rear washer piping advice

[M88RCC]

Notice that when I tried to use the rear window washer that nothing was happening but I still heard a gush of water, it turns out that there was a hole in the piping half way up the drivers side pipe see attached pictures.

Now It seems like this leak has cause damage to the rear demister as well, I did notice that this wasn't working and this is the reason why.

Question is, now that I have cut the offending hole out of the piping how to I join them back up? I am looking for suggestions here, so any welcome at all.

Also what would be involved in getting the rear demister to work again, I have noticed that the right hand side control unit? has been taken out, presumable to stop more damage being done by trying to turn it on.

Cheers

 

[LEE69]

go to an aquarium shop they sell different size straight joiners

 

[M88RCC]

@LEE69

Thanks for the reply

Even though the hose is not a rubber hose?

It's a plastic ridged hose if you follow me, I tried to join them with a single piece of rubber hose I had but it ended up popping off.

Cheers

 

[LEE69]

Yeah should ok only pennies anyway push fit i bet

 

[M88RCC]

Ok,

Will have a try and that but there is a space that needs to be filled where I cut the burnt bit out, this gap is about 4cm in length.

 

[LEE69]

just get the air pipe whilst there too, to join it, be fine for water

 

[M88RCC]

Anyone got any advice on the rear demister, ideas how I can fix it?

Cheers