Hi All,
This is my first post here!
I have been a long time lurker here on this forum and have just used my OBDEleven to enable the sport displays in my Virtual Cockpit. My car is the 2017 FL A3 with Tech Pack (VC etc).
I have enabled the sports displays on the VC and I have been reading on here that people don't think that the car has the ability to read these values if it is not an S3 or an RS3.
After a little bit of testing and tiny throttle movements, I can get the display to shot either 25%, 50%, 75% or 100%.
However, all of these values happen in a really short travel of the accelerator. Could it be possible to scale remap this scale to stretch over the full torque range rather than a small 5% of it?
I am not super familiar with the long coding, but perhaps there is a way to scale these values?
Any advice or thoughts would be much appreciated!
Harry
This is my first post here!
I have been a long time lurker here on this forum and have just used my OBDEleven to enable the sport displays in my Virtual Cockpit. My car is the 2017 FL A3 with Tech Pack (VC etc).
I have enabled the sports displays on the VC and I have been reading on here that people don't think that the car has the ability to read these values if it is not an S3 or an RS3.
After a little bit of testing and tiny throttle movements, I can get the display to shot either 25%, 50%, 75% or 100%.
However, all of these values happen in a really short travel of the accelerator. Could it be possible to scale remap this scale to stretch over the full torque range rather than a small 5% of it?
I am not super familiar with the long coding, but perhaps there is a way to scale these values?
Any advice or thoughts would be much appreciated!
Harry