Retrofitter North West

[hulksta786]

Hi,

Are there any retrofitters in the North West area?

I have an Audi A3 2009 facelift.
I have bought a rear bumper with factory parking sensors which now need wiring in.
Control module, wiring loom to to the front and buzzer have all been bought and needs fitting in.

Thank you

 

[s8craig]

Nothing should need to wired to the front if it's only rear sensors. Buzzer sits in the back along with the control module.

 

[hulksta786]

Nothing should need to wired to the front if it's only rear sensors. Buzzer sits in the back along with the control module.

So where does the loom plug into?
One plug goes into the control module, one plug is these for the buzzer.
Then there are four remaining wires. One appears to be a ground, there are two exposed wires twisted together, and one wire with a with some form of small connector.

 

[s8craig]

These are canbus wires and go into the relevant canbus, probably comfort from memory. They should go into a canbus connector, usually a multipin (32) connector with each of the available can bus types in, comfort, drivetrain etc. I've never done parking sensors on an A3 so cannot really help you any further.