Fuse for power seats

[jarnold231]

Just in the process of installing the S4 Recaro front seats I bought. Put them in

Black connector with 2x wires connected
Yellow airbag connector installed
No Green
Red connector not installed as no socket for it atm.

Not getting any power to the seats to move them.

Assuming this could be a fuse issue. But cannot see any relevant fuse slot on my diagram for it.

Any one got any ideas?

Sent from my ONEPLUS A6013 using Tapatalk

 

[Charlie Farley]

The black socket is the pressure control module connection.
The green socket is for heated seats
The red socket is for powering the seat (reclining, lumbar, etc)
The yellow socket is for the seat’s airbag.

 

[jarnold231]

The black socket is the pressure control module connection.
The green socket is for heated seats
The red socket is for powering the seat (reclining, lumbar, etc)
The yellow socket is for the seat’s airbag.

Ah. C'est une problem then. Going to have to wire the red socket in.

I'm guessing this isn't going to be particularly simple then. I thought red was for the memory related element rather than the power to the seat.

I've messages kufatec to see if this is the part I'm going to need : https://www.kufatec.com/en/comfort-...djustment-lordosis-for-audi-a4-b7-a4-b6-33857

But looking about at different sites it would appear not.

Sent from my ONEPLUS A6013 using Tapatalk

 

[Rabbit 16v]

There is a fuse behind the kick panel on each side. Just went through this today.

all plugs were direct fit for me. I did use B6 recaros though. No issue at all other than the needed swap of the pressure sensor on the passenger seat and seat belt pyrotechnic jobbie on the rear seat. After that, no airbag codes and everything works as expected.