2007 Can roof not working vagcom reads this

[Tiprat]

Morning everyone, so a friend has a 2007 cabriolet and the roof stopped working, it's been read by vagcom and the codes are, (see picture), can anyone offer a bit of advice on what I'm looking for, or what needs fixing/replacing.

 

[Frank_UK]

Check out the fault library here http://www.vagpro.co.uk/fault-library/#A4-Fault-Library
Depending how the hood behaves that should provide some steer to the issue. On my 2007 it turned out to be the brushes on my hood motor, which Khurrum (Vagpro) fixed under 15 minutes at a very reasonable cost and appears to be the most common fault.
You can also run the hood through a manual opening/closing sequence as per manual, which some have had limited success with resetting sensors.
Can't comment on fault codes, others may have a better idea.

 

[Tiprat]

Check out the fault library here http://www.vagpro.co.uk/fault-library/#A4-Fault-Library
Depending how the hood behaves that should provide some steer to the issue. On my 2007 it turned out to be the brushes on my hood motor, which Khurrum (Vagpro) fixed under 15 minutes at a very reasonable cost and appears to be the most common fault.
You can also run the hood through a manual opening/closing sequence as per manual, which some have had limited success with resetting sensors.
Can't comment on fault codes, others may have a better idea.

Check out the fault library here http://www.vagpro.co.uk/fault-library/#A4-Fault-Library
Depending how the hood behaves that should provide some steer to the issue. On my 2007 it turned out to be the brushes on my hood motor, which Khurrum (Vagpro) fixed under 15 minutes at a very reasonable cost and appears to be the most common fault.
You can also run the hood through a manual opening/closing sequence as per manual, which some have had limited success with resetting sensors.
Can't comment on fault codes, others may have a better idea.than

 

[Tiprat]

Thanks for the reply, before posting we changed the roof motor for a working one, and it made no difference, we have done the manual "roof down roof up reset" and no difference, there appears to be no power going to the roof motor, so can only assume that something is either broken or faulty further upstream of the motor so it's getting no signal to power up and work, was hoping the vagcom would point us in the direction of the fault. The machanic who did the scan could offer no help so hence asking on here.